Lyhenteet

Verkkokauppa

Takaisin

ASTM B111/B111M-18 RLV

Standard Specification for Copper and Copper-Alloy Seamless Condenser Tubes and Ferrule Stock

Soveltamisala
1.1 This specification2 establishes the requirements for seamless tube and ferrule stock of copper and various copper alloys up to 31/8 in. [80 mm] inclusive, in diameter, for use in surface condensers, evaporators, and heat exchangers. The following coppers and copper alloys are specified:3 Copper or Copper Alloy UNS No. Previously Used Designation Description C10100 OFE Oxygen-free electronic C10200 OFA Oxygen-free without residual deoxidants C10300 . . . Oxygen-free, extra low phosphorus C10800 . . . Oxygen-free, low phosphorus C12000 DLPA Phosphorized, low residual phosphorus C12200 DHPA Phosphorized, high residual phosphorus C14200 DPAA Phosphorized, arsenical C19200 . . . Phosphorized, 1 % iron C23000 . . . Red Brass C28000 . . . Muntz Metal C44300 . . . Admiralty Metals, B, C, and D C44400 . . . . . . C44500 . . . . . . C60800 . . . Aluminum Bronze C61300 . . . . . . C61400 . . . Aluminum Bronze, D C68700 . . . Aluminum Brass, B C70400 . . . 95-5 Copper-Nickel C70600 . . . 90-10 Copper-Nickel C70620 . . . 90-10 Copper-Nickel—Welding Grade C71000 . . . 80-20 Copper-Nickel C71500 . . . 70-30 Copper-Nickel C71520 . . . 70-30 Copper-Nickel—Welding Grade C71640 . . . Copper-nickel-iron-manganese C72200 . . . . . . (A) Designations listed in Classification B224. 1.2 Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.3 The following safety hazards caveat pertains only to the test methods portion, Section 19, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. (Warning—Mercury has been designated by many regulatory agencies as a hazardous substance that can cause serious medical issues. Mercury, or its vapor, has been demonstrated to be hazardous to health and corrosive to materials. Caution should be taken when handling mercury and mercury containing products. See the applicable product Safety Data Sheet (SDS) for additional information. Users should be aware that selling mercury and/or mercury containing products in your state or country may be prohibited by law.) 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Sidokset
Velvoittavat viittaukset
Tässä julkaisussa ei ole velvoittavia viittauksia
Tekninen komitea
Vahvistuspäivä
01.03.2018
Julkaisupäivä
01.03.2018
Sivumäärä
12
Julkaisun kieli
englanti

Takaisin