Lyhenteet

Verkkokauppa

Takaisin

ASTM B196/B196M-18 RLV

Standard Specification for Copper-Beryllium Alloy Rod and Bar

Soveltamisala
1.1 This specification establishes the requirements for copper-beryllium alloy rod and bar in straight lengths. The following three alloys are included: Copper Alloy UNS No. Previously Used Designations Nominal Beryllium Content, % C17000 Alloy 165 1.7 C17200 Alloy 25 1.9 C17300 1.9 +0.4 lead 1.2 Unless otherwise required, Copper Alloy UNS No. C17200 shall be the alloy furnished whenever Specification B196/B196M is specified without any alloy designation. 1.3 The values stated in either inch-pounds or SI units are to be regarded separately as the standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the specification. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Sidokset
Velvoittavat viittaukset
Tässä julkaisussa ei ole velvoittavia viittauksia
Tekninen komitea
Vahvistuspäivä
01.03.2018
Julkaisupäivä
01.03.2018
Sivumäärä
5
Julkaisun kieli
englanti

Takaisin