Lyhenteet

- A / A +

Takaisin

SFS-EN 1501-3:en Kumottu

Refuse collection vehicles and their associated lifting devices. General requirements and safety requirements. Part 3: Front loaded refuse collection vehicles

Tuote ladattavissa heti Toimitusaika on noin 1 - 2 työpäivää Toimitusaika on 3 - 5 työpäivää.
Soveltamisala
Suomenkielistä soveltamisalaa ei ole saatavissa.

This standard applies to front loaded refuse collection vehicles, as defined in 3.2, and specifies their technical requirements.
This standard deals with all significant hazards, hazardous situations and events relevant to the front loaded RCV, when it is used as intended and under conditions of misuse which are reasonably foreseeable by the manufacturer (see Clause 4).
This standard part 3 describes and gives the requirements of the front loaded RCV and the associated lifting device(s) and refers to part 4 of this series of standards for the noise test code.
Examples for standard types of front loaded refuse collection vehicles are given in Annex C.
This European Standard is not applicable to:
? operation in severe conditions (e.g. extreme environmental conditions such as: temperatures below –25 °C and above 40 °C, corrosive environment, tropical environment, lightning, wind velocity in excess of 75 km/h);
? operation subject to special rules (e.g. potentially explosive atmospheres, contaminating environments);
? transportation of passengers, lifting of persons;
? loading by crane;
? loading by satellite vehicle;
? containers other than defined in EN 840-1 to -4, EN 12574-1 to -3 and type B of EN 13071;
? handling of loads the nature of which could lead to dangerous situations such as hot wastes, acids and bases, radioactive materials, especially fragile loads, explosives.
This document is not applicable to machinery which is manufactured before the date of its publication by CEN.


Tämän julkaisun valmistelusta Suomessa vastaa Yhteinen Toimialaliitto, www.ytl.fi.
Sidokset
Velvoittavat viittaukset
EN 1032:2003+A1:2008 Mechanical vibration - Testing of mobile machinery in order to determine the vibration emission value
EN 1050:1996 Safety of machinery - Principles for risk assessment
EN 1088:1995 Safety of machinery - Interlocking devices associated with guards - Principles for design and selection
Direktiivi
98/37/EC Koneturvallisuus
2006/42/EC Koneturvallisuus

http://ec.europa.eu »
Vahvistuspäivä
08.09.2008
Kumouspäivä
09.04.2021
Painos
1
Sivumäärä
64
Julkaisun kieli
englanti

Takaisin