ISO 4064-4:2014 applies to water meters used to meter the volume of cold potable water and hot water flowing through a fully charged, closed conduit. These water meters incorporate devices which indicate the integrated volume. ISO 4064-4:2014 specifies technical characteristics and pressure loss requirements for meters for cold potable water and hot water. It applies to water meters which can withstand: a) a maximum admissible working pressure (MAP) equal to at least 1 MPa [0,6 MPa for meters for use with pipe nominal diameters (DNs) =500 mm]; b) a maximum admissible temperature (MAT) for cold potable water meters of 30 °C; c) a MAT for hot water meters up to 180 °C, depending on class. In addition to meters based on mechanical principles, ISO 4064-4:2014 also applies to water meters based on electrical or electronic principles, and to water meters based on mechanical principles incorporating electronic devices, used to meter the volume flow of hot water and cold potable water. It also applies to electronic ancillary devices. As a rule ancillary devices are optional. However, national or international regulations may make some ancillary devices mandatory in relation to the utilization of the water meter.
Tämän julkaisun valmistelusta Suomessa vastaa Metalliteollisuuden Standardisointiyhdistys ry, puh. 09 19 231 (vaihde).
Sisällysluettelo
Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Technical characteristics
4.1 In-line meters
4.2 Concentric and cartridge meters and exchangeable metrological modules
Annex A Concentric water meter manifold (informative)
Annex B Connection interfaces — Solutions for cartridge meters (normative)
Annex C Examples of adaptors and converters (informative)
ISO 228-1:2000 Pipe threads where pressure-tight joints are not made on the threads -- Part 1: Dimensions, tolerances and designation
ISO 4064-1:2014 Water meters for cold potable water and hot water -- Part 1: Metrological and technical requirements
ISO 7005-2:1988 Metallic flanges -- Part 2: Cast iron flanges
ISO 228-1:2000 Pipe threads where pressure-tight joints are not made on the threads -- Part 1: Dimensions, tolerances and designation
ISO 4064-1:2014 Water meters for cold potable water and hot water -- Part 1: Metrological and technical requirements
ISO 7005-2:1988 Metallic flanges -- Part 2: Cast iron flanges
ISO 7005-3:1988 Metallic flanges -- Part 3: Copper alloy and composite flanges