Verkkokauppa
SFS-EN ISO 7250-1:2017:en
Basic human body measurements for technological design. Part 1: Body measurement definitions and landmarks (ISO 7250-1:2017)
Soveltamisala
Suomenkielistä soveltamisalaa ei ole saatavissa.
ISO 7250-1:2017 provides a description of anthropometric measurements which can be used as a basis for comparison of population groups and for the creation of anthropometric databases (see ISO 15535). The basic list of measurements specified in this document is intended to serve as a guide for ergonomists who are required to define population groups and apply their knowledge to the geometric design of the places where people work and live. In addition, the list serves as a basis for extracting one- and two-dimensional measurements from three-dimensional scans (specified in ISO 20685). It serves as a guide on how to take anthropometric measurements, but also gives information to the ergonomist and designer on the anatomical and anthropometrical bases and principles of measurement which are applied in the solution of design tasks.
ISO 7250-1:2017 is intended to be used in conjunction with national or international regulations or agreements to ensure harmony in defining population groups and to allow comparison of anthropometric data among member bodies. In its various applications, it is anticipated that the basic list will be supplemented by specific additional measurements. Annex A shows the correspondence of dimensions described here with their use in ISO 14738 and ISO 15534.
Tämän julkaisun valmistelusta Suomessa vastaa Metalliteollisuuden Standardisointiyhdistys ry, puh. 09 19 231 (vaihde).
ISO 7250-1:2017 provides a description of anthropometric measurements which can be used as a basis for comparison of population groups and for the creation of anthropometric databases (see ISO 15535). The basic list of measurements specified in this document is intended to serve as a guide for ergonomists who are required to define population groups and apply their knowledge to the geometric design of the places where people work and live. In addition, the list serves as a basis for extracting one- and two-dimensional measurements from three-dimensional scans (specified in ISO 20685). It serves as a guide on how to take anthropometric measurements, but also gives information to the ergonomist and designer on the anatomical and anthropometrical bases and principles of measurement which are applied in the solution of design tasks.
ISO 7250-1:2017 is intended to be used in conjunction with national or international regulations or agreements to ensure harmony in defining population groups and to allow comparison of anthropometric data among member bodies. In its various applications, it is anticipated that the basic list will be supplemented by specific additional measurements. Annex A shows the correspondence of dimensions described here with their use in ISO 14738 and ISO 15534.
Tämän julkaisun valmistelusta Suomessa vastaa Metalliteollisuuden Standardisointiyhdistys ry, puh. 09 19 231 (vaihde).
Sisällysluettelo
Tuoteryhmä(t)
Sidokset
Velvoittavat viittaukset
Tässä julkaisussa ei ole velvoittavia viittauksia
Tekninen komitea
Vahvistuspäivä
06.10.2017
Julkaisupäivä
10.10.2017
Painos
2
Sivumäärä
57
Julkaisun kieli
englanti