Protective clothing for firefighters. Physiological impact. Part 2: Determination of physiological heat load caused by protective clothing worn by firefighters (ISO 18640-2:2018)
Tuote ladattavissa hetiToimitusaika on noin 1 - 2 työpäivääToimitusaika on 3 - 5 työpäivää.
This document specifies a method for evaluating the thermo-physiological impact of protective fabric ensembles and potentially protective clothing ensembles in a simulated activity under defined relevant conditions for firefighters. This document is intended to be used to assess the thermo-physiological impact of protective fabric ensembles and potentially protective clothing ensembles but not the risk for heat stress due to actual fire conditions. The results of this test method can be used as elements of characterisation and comparison of thermo-physiological impact of various types of protective fabric ensembles and potentially protective clothing ensembles. Default measurements are undertaken on fabric samples representing the garment or protective clothing combination. Optionally and in addition to the standard test method, the same testing protocol can be applied to characterise protective clothing ensembles including underwear, air layers and certain design features[1]. In addition measurements on readymade garments are optionally possible. NOTE The presently used evaluation methods are only validated for structural firefighting garments.
[1] A study conducted at Empa (Swiss Federal Laboratories for Materials Science and Technology, Switzerland) showed good correlation between results of standard torso tests (without both underwear and air layers on fabrics) to tests on fabrics with underwear, tests on fabrics with underwear and air layers and test on readymade garments (with underwear and with or without air layers) of the same material composition. Due to the different thermal insulation of the systems direct comparison of the results is not possible.
Tämän julkaisun valmistelusta Suomessa vastaa SFS Suomen Standardit, puh. 09 149 9331.
Sisällysluettelo
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and abbreviations
5 Evaluation method
5.1 General
5.2 Firefighting scenarios
5.3 THS measurement
6 Measurement
6.1 General
6.2 THS measurement
7 Test report
7.1 General
7.2 Predicted physiological parameters
7.3 Contents of test report
Annex A Single-sector Thermo-physiological Human Simulator (THS) (normative)
Annex B Example measurement protocol according to ISO 18640-2 (informative)
Annex C Scenarios for testing and limitation of system (informative)
ISO 11092:2014 Textiles -- Physiological effects -- Measurement of thermal and water-vapour resistance under steady-state conditions (sweating guarded-hotplate test)
ISO 18640-1:2018 Protective clothing for firefighters -- Physiological impact -- Part 1: Measurement of coupled heat and moisture transfer with the sweating torso
ISO 11092:2014 Textiles -- Physiological effects -- Measurement of thermal and water-vapour resistance under steady-state conditions (sweating guarded-hotplate test)
ISO 18640-1:2018 Protective clothing for firefighters -- Physiological impact -- Part 1: Measurement of coupled heat and moisture transfer with the sweating torso