This document specifies the rules and graphical symbols for the representations of splines and serrations in technical product documentation. Two methods of representation are specified: a) complete representation; b) simplified representation. The rules and graphical symbols specified in this document are applicable to detail drawings of parts (shafts and hubs) and to assembly drawings of joints. NOTE For uniformity, all the figures in this document have been drawn in the first-angle orthographic projection. A third-angle orthographic projection could equally have been used without prejudice to principles established.
Tämän julkaisun valmistelusta Suomessa vastaa Metalliteollisuuden Standardisointiyhdistys ry, puh. 09 19 231 (vaihde).
Sisällysluettelo
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Designation
4.1 Graphical symbols
4.2 Method for indication designation
5 Complete representation of spline joints
6 Simplified representation
6.1 General
6.2 Representation of details (shafts and hubs)
7 Assembly drawings
Annex A Proportions and dimensions of graphical symbols (normative)
ISO 128-24:2014 Technical drawings -- General principles of presentation -- Part 24: Lines on mechanical engineering drawings
ISO 3098-2:2000 Technical product documentation -- Lettering -- Part 2: Latin alphabet, numerals and marks
ISO 128-24:2014 Technical drawings -- General principles of presentation -- Part 24: Lines on mechanical engineering drawings
ISO 3098-2:2000 Technical product documentation -- Lettering -- Part 2: Latin alphabet, numerals and marks