NEW!IEC 60364-7-722:2018 is available as IEC 60364-7-722:2018 RLV which contains the International Standard and its Redline version, showing all changes of the technical content compared to the previous edition.IEC 60364-7-722:2018 applies to:
• circuits intended to supply energy to electric vehicles, and
• circuits intended for feeding back electricity from electric vehicles.
Circuits covered by this document are terminated at the connecting point.
This edition includes the following significant technical changes with respect to the previous edition:
a) introduction of requirements for electrical installations incorporating wireless power transfer systems;
b) clarification of the requirements regarding the protective measure placing out of reach in order to allow the use of pantographs in areas accessible to the public;
c) introduction of requirements covering the case where the EV may operate as a source in parallel with other sources.
NOTE 1 The requirements for EV supply equipment for conductive charging and the relevant charging modes are described in IEC 61851 (all parts). The requirements for EV supply equipment for wireless power transfer are described in IEC 61980 (all parts).
NOTE 2 IEC 60364-7-722 does not cover the assessment of the risk of explosion due to the possible production of hydrogen/other flammable gases during the battery recharging phase.
Tämän julkaisun valmistelusta Suomessa vastaa SESKO ry, puh. 050 571 6048.
EN 60309-1:1999 Teollisuuskäyttöön tarkoitetut voimapistokytkimet. Osa 1: Yleiset vaatimukset
EN 60309-2:1992 Plugs, socket-outlets and couplers for industrial purposes - Part 2: Dimensional interchangeability requirements for pin and contact-tube accessories of harmonized configurations
EN 60309-2:1998 Plugs, socket-outlets and couplers for industrial purposes - Part 2: Dimensional interchangeability requirements for pin and contact-tube accessories
EN 60309-1:1999 Teollisuuskäyttöön tarkoitetut voimapistokytkimet. Osa 1: Yleiset vaatimukset
EN 60309-2:1992 Plugs, socket-outlets and couplers for industrial purposes - Part 2: Dimensional interchangeability requirements for pin and contact-tube accessories of harmonized configurations
EN 60309-2:1998 Plugs, socket-outlets and couplers for industrial purposes - Part 2: Dimensional interchangeability requirements for pin and contact-tube accessories
EN 60309-2:1999 Teollisuuskäyttöön tarkoitetut voimapistokytkimet. Osa 2: Mitoitusvaatimukset
EN 60898-1:2003 Electrical accessories - Circuit breakers for overcurrent protection for household and similar installations - Part 1: Circuit-breakers for a.c. operation
EN 60898-1:2003/A11:2005 Electrical accessories - Circuit breakers for overcurrent protection for household and similar installations - Part 1: Circuit-breakers for a.c. operation
EN 60898-1:2003/A12:2008 Electrical accessories - Circuit breakers for overcurrent protection for household and similar installations - Part 1: Circuit-breakers for a.c. operation
EN 60898-1:2003/A13:2012 Electrical accessories - Circuit breakers for overcurrent protection for household and similar installations - Part 1: Circuit-breakers for a.c. operation
EN 60898-1:2003/A1:2004 Electrical accessories - Circuit breakers for overcurrent protection for household and similar installations - Part 1: Circuit-breakers for a.c. operation
EN 60898-1:2003/IS1:2007 Electrical accessories - Circuit breakers for overcurrent protection for household and similar installations - Part 1: Circuit-breakers for a.c. operation
EN 60898-1:2003/IS2:2007 Electrical accessories - Circuit breakers for overcurrent protection for household and similar installations - Part 1: Circuit-breakers for a.c. operation
EN 60898-1:2003/IS3:2007 Electrical accessories - Circuit breakers for overcurrent protection for household and similar installations - Part 1: Circuit-breakers for a.c. operation
EN 60898-1:2003/IS4:2007 Electrical accessories - Circuit breakers for overcurrent protection for household and similar installations - Part 1: Circuit-breakers for a.c. operation
EN 60898-1:2019 Electrical accessories - Circuit-breakers for overcurrent protection for household and similar installations - Part 1: Circuit-breakers for a.c. operation
EN 60898-2:2001 Circuit-breakers for overcurrent protection for household and similar installations - Part 2: Circuit-breakers for a.c. and d.c. operation
EN 60898-2:2006 Electrical accessories - Circuit-breakers for overcurrent protection for household and similar installations - Part 2: Circuit-breakers for a.c. and d.c. operation
EN 60898-2:2021 Electrical accessories - Circuit-breakers for overcurrent protection for household and similar installations - Part 2: Circuit-breakers for a.c. and d.c. operation
EN 60947-2:2017 Low-voltage switchgear and controlgear - Part 2: Circuit-breakers
EN 60947-6-2:2003 Low-voltage switchgear and controlgear - Part 6-2: Multiple function equipment - Control and protective switching devices (or equipment) (CPS)
EN 61008-1:2012 Residual current operated circuit-breakers without integral overcurrent protection for household and similar uses (RCCBs) - Part 1: General rules
EN 61009-1:2012 Residual current operated circuit-breakers with integral overcurrent protection for household and similar uses (RCBOs) - Part 1: General rules
EN 61557-8:2015 Electrical safety in low voltage distribution systems up to 1 000 V a.c. and 1 500 V d.c. - Equipment for testing, measuring or monitoring of protective measures - Part 8: Insulation monitoring devices for IT systems
EN 61558-2-4:2009 Safety of transformers, reactors, power supply units and similar products for supply voltages up to 1 100 V - Part 2-4: Particular requirements and tests for isolating transformers and power supply units incorporating isolating transformers
EN 62196-1:2014 Plugs, socket-outlets, vehicle connectors and vehicle inlets - Conductive charging of electric vehicles - Part 1: General requirements
EN 62196-2:2017 Plugs, socket-outlets, vehicle connectors and vehicle inlets - Conductive charging of electric vehicles - Part 2: Dimensional compatibility and interchangeability requirements for a.c. pin and contact-tube accessories
EN 62196-3:2014 Plugs, socket-outlets, vehicle connectors and vehicle inlets - Conductive charging of electric vehicles - Part 3: Dimensional compatibility and interchangeability requirements for d.c. and a.c./d.c. pin and contact-tube vehicle couplers
EN 62262:2002 Sähkölaitteiden kotelointien mekaanisen iskunkestävyyden lujuusluokat (IK-koodi)
EN 62423:2012 Type F and type B residual current operated circuit-breakers with and without integral overcurrent protection for household and similar uses
EN IEC 60309-2:2022 Plugs, fixed or portable socket-outlets and appliance inlets for industrial purposes - Part 2: Dimensional compatibility requirements for pin and contact-tube accessories
EN IEC 60947-6-2:2023 Low-voltage switchgear and controlgear - Part 6-2: Multiple function equipment - Control and protective switching devices (or equipment) (CPS)
EN IEC 61851-1:2019 Electric vehicle conductive charging system - Part 1: General requirements
EN IEC 61851-25:2021 Electric vehicle conductive charging system - Part 25: DC EV supply equipment where protection relies on electrical separation
EN IEC 62196-1:2022 Plugs, socket-outlets, vehicle connectors and vehicle inlets - Conductive charging of electric vehicles - Part 1: General requirements
EN IEC 62196-2:2022 Plugs, socket-outlets, vehicle connectors and vehicle inlets - Conductive charging of electric vehicles - Part 2: Dimensional compatibility requirements for AC pin and contact-tube accessories
EN IEC 62196-3:2022 Plugs, socket-outlets, vehicle connectors and vehicle inlets - Conductive charging of electric vehicles - Part 3: Dimensional compatibility requirements for DC and AC/DC pin and contact-tube vehicle couplers
EN IEC 62196-6:2022 Plugs, socket-outlets, vehicle connectors and vehicle inlets - Conductive charging of electric vehicles - Part 6: Dimensional compatibility requirements for DC pin and contact-tube vehicle couplers intended to be used for DC EV supply equipment where protection relies on electrical separation
HD 60269-2:2013 Low-voltage fuses - Part 2: Supplementary requirements for fuses for use by authorized persons (fuses mainly for industrial application) - Examples of standardized systems of fuses A to K
HD 60269-2:2013/A1:2022 Low-voltage fuses - Part 2: Supplementary requirements for fuses for use by authorized persons (fuses mainly for industrial application) - Examples of standardized systems of fuses A to K
HD 60269-3:2007 Low-voltage fuses - Part 3: Supplementary requirements for fuses for use by unskilled persons (fuses mainly for household or similar applications) - Examples of standardized systems of fuses A to F
HD 60269-3:2010 Low-voltage fuses - Part 3: Supplementary requirements for fuses for use by unskilled persons (fuses mainly for household and similar applications) - Examples of standardized systems of fuses A to F
HD 60269-3:2010/A1:2013 Low-voltage fuses - Part 3: Supplementary requirements for fuses for use by unskilled persons (fuses mainly for household and similar applications) - Examples of standardized systems of fuses A to F
HD 60269-3:2010/A2:2022 Low-voltage fuses - Part 3: Supplementary requirements for fuses for use by unskilled persons (fuses mainly for household or similar applications) - Examples of standardized systems of fuses A to F
HD 60364-4-41:2007/A11:2017 Low-voltage electrical installations - Part 4-41: Protection for safety - Protection against electric shock
HD 60364-4-41:2017 Low-voltage electrical installations - Part 4-41: Protection for safety - Protection against electric shock
HD 60364-4-41:2017/A11:2017 Low-voltage electrical installations - Part 4-41: Protection for safety - Protection against electric shock
HD 60364-4-41:2017/A12:2019 Low-voltage electrical installations - Part 4-41: Protection for safety - Protection against electric shock
HD 60364-4-42:2011 Low voltage electrical installations - Part 4-42: Protection for safety - Protection against thermal effects
HD 60364-4-42:2011/A11:2021 Low voltage electrical installations - Part 4-42: Protection for safety - Protection against thermal effects
HD 60364-4-42:2011/A1:2015 Low voltage electrical installations - Part 4-42: Protection for safety - Protection against thermal effects
HD 60364-4-43:2010 Low-voltage electrical installations - Part 4-43: Protection for safety - Protection against overcurrent
HD 60364-4-43:2023 Low-voltage electrical installations - Part 4-43: Protection for safety - Protection against overcurrent
HD 60364-4-442:2012 Low-voltage electrical installations - Part 4-442: Protection for safety - Protection of low-voltage installations against temporary overvoltages due to earth faults in the high-voltage system and due to faults in the low voltage system
HD 60364-4-443:2006 Electrical installations of buildings - Part 4-44: Protection for safety - Protection against voltage disturbances and electromagnetic disturbances - Clause 443: Protection against overvoltages of atmospheric origin or due to switching
HD 60364-4-443:2016 Low-voltage electrical installations - Part 4-44: Protection for safety - Protection against voltage disturbances and electromagnetic disturbances - Clause 443: Protection against transient overvoltages of atmospheric origin or due to switching
HD 60364-4-444:2010 Low-voltage electrical installations - Part 4-444: Protection for safety - Protection against voltage disturbances and electromagnetic disturbances
HD 60364-4-46:2016 Low-voltage electrical installations - Part 4-46: Protection for safety - Isolation and switching
HD 60364-4-46:2016/A11:2017 Low-voltage electrical installations - Part 4-46: Protection for safety - Isolation and switching
HD 60364-8-2:2018 Low-voltage electrical installations - Part 8-2: Prosumer's low-voltage electrical installations
IEC 60364-4-41:2005/A1:2017 Amendment 1 - Low voltage electrical installations - Part 4-41: Protection for safety - Protection against electric shock
IEC/TS 62196-4:201X
prEN 62955:2016 Residual Direct Current Monitoring Device to be used for Mode 3 charging of Electric Vehicle