SFS-EN IEC 61300-2-44:2024:en

Scope

IEC 61300-2-44:2024 specifies a test to determine the influence of flexing under tensile load of the strain relief of fibre optic interconnecting devices or components. The intention is to simulate the number of flexing cycles which would typically be experienced during service life. This test is applied to both single fibre cable and multiple fibre cable. This fourth edition cancels and replaces the third edition published in 2013. This edition constitutes a technical revision. This edition includes the following significant technical changes with respect to the previous edition: a) replaced active monitoring with transient loss for measurements during test; b) harmonized recommended severities according to IEC 61753-1.

The standards writing body responsible for this document in Finland is Electrotechnical Standardization in Finland.

Product group(s)

33.180.20 Fibre optic interconnecting devices »

Relationships

Normative references

EN 61300-3-1:2005 Fibre optic interconnecting devices and passive components - Basic test and measurement procedures - Part 3-1: Examinations and measurements - Visual examination
EN 61300-3-28:2012 Fibre optic interconnecting devices and passive components - Basic test and measurement procedures - Part 3-28: Examinations and measurements - Transient loss
EN 61753-031-2:2014 Fibre optic interconnecting devices and passive components - Performance standard - Part 031-2: Non-connectorized single-mode 1×N and 2×N non-wavelength-selective branching devices for Category C - Controlled environment

EN 61300-3-1:2005 Fibre optic interconnecting devices and passive components - Basic test and measurement procedures - Part 3-1: Examinations and measurements - Visual examination
EN 61300-3-28:2012 Fibre optic interconnecting devices and passive components - Basic test and measurement procedures - Part 3-28: Examinations and measurements - Transient loss
EN 61753-031-2:2014 Fibre optic interconnecting devices and passive components - Performance standard - Part 031-2: Non-connectorized single-mode 1×N and 2×N non-wavelength-selective branching devices for Category C - Controlled environment
EN 61753-031-3:2009 Fibre optic interconnecting devices and passive components performance standard - Part 031-3: Non-connectorized single-mode 1xN and 2xN non-wavelength-selective branching devices (NWBD) for Category U - Uncontrolled environment
EN 61753-031-3:2015 Fibre optic interconnecting devices and passive components - Performance standard - Part 031-3: Non-connectorized single-mode 1×N and 2×N non-wavelength-selective branching devices for Category U - Uncontrolled environment
EN 61753-031-6:2014 Fibre optic interconnecting devices and passive components - Performance standard - Part 031-6: Non-connectorized single-mode 1xN and 2xN non-wavelength-selective branching devices for Category O - Uncontrolled environment
EN 62005-1:2001 Reliability of fibre optic interconnecting devices and passive components - Part 1: Introductory guide and definitions
EN 62005-2:2001 Reliability of fibre optic interconnecting devices and passive components - Part 2: Quantitative assessment of reliability based on accelerated ageing tests - Temperature and humidity; steady state
EN 62005-3:2001 Reliability of fibre optic interconnecting devices and passive components - Part 3: Relevant tests for evaluating failure modes and failure mechanisms for passive components
EN 62005-4:1999 Reliability of fibre optic interconnecting devices and passive optical components - Part 4: Product screening
EN 62005-7:2004 Reliability of fibre optic interconnecting devices and passive optical components - Part 7: Life stress modeling
EN IEC 61300-1:2022 Fibre optic interconnecting devices and passive components - Basic test and measurement procedures - Part 1: General and guidance

Technical committee

CLC/TC 86BXA Fibre optic interconnect, passive and connectorised components »

Date of implementation

19.04.2024

Published

23.04.2024

Edition

1

Pages

13

Language(s)

English