IEC TS 62782:2016(E) provides a test method for performing a cyclic (dynamic) mechanical load test in which the module is supported at the design support points and a uniform load normal to the module surface is cycled in alternating negative and positive directions. This test may be utilized to evaluate if components within the module including solar cells, interconnect ribbons and/or electrical bonds within the module are susceptible to breakage or if edge seals are likely to fail due to the mechanical stresses encountered during installation and operation. This test can be performed at any module temperature within the normal operating temperature range. This test has been written as a standalone technical specification, but it is likely to be used in conjunction with other test standards.
IEC 61215-1:2016 Terrestrial photovoltaic (PV) modules – Design qualification and type approval – Part 1: Test requirements
IEC 61215-2:2016 Terrestrial photovoltaic (PV) modules – Design qualification and type approval – Part 2: Test procedures
IEC TS 60904-12 Photovoltaic devices – Part 12: Infrared thermography of photovoltaic modules1
IEC 61215-1:2016 Terrestrial photovoltaic (PV) modules – Design qualification and type approval – Part 1: Test requirements
IEC 61215-2:2016 Terrestrial photovoltaic (PV) modules – Design qualification and type approval – Part 2: Test procedures
IEC TS 60904-12 Photovoltaic devices – Part 12: Infrared thermography of photovoltaic modules1
IEC TS 60904-13 Photovoltaic devices – Part 13: Electroluminescence of photovoltaic modules1
IEC TS 61836 Solar photovoltaic energy systems – Terms, definitions and symbols
ISO/IEC 17025 General requirements for the competence of testing and calibration laboratories