Thermal insulation products for building equipment and industrial installations. In-situ thermal insulation formed from expanded perlite (EP) products. Part 1: Specification for bonded and loose-fill products before installation
Tuote ladattavissa hetiToimitusaika on noin 1 - 2 työpäivääToimitusaika on 3 - 5 työpäivää.
This European Standard specifies the requirements for expanded perlite products which are used for the thermal insulation of building equipment and industrial installations with an operating temperature in the range of approximately –270 ºC to +650 ºC. This European Standard specifies the requirements for the four types of expanded perlite products Perlite Aggregate (EPA), Coated Perlite (EPC), Hydrophobic Perlite (EPH) and Premixed Perlite (EPM), containing less than 1 % by mass organic material as determined by Annex C. This European Standard is a specification for the insulation products before installation. This European Standard describes the product characteristics and includes procedures for testing, evaluation of conformity, marking and labelling. This European Standard does not specify the required level of a given property to be achieved by a product to demonstrate fitness for purpose in a particular application. The levels required for a given application are to be found in regulations or non-conflicting standards. This European Standard does not cover factory made insulation products of formed shapes and boards made with expanded perlite, and does not cover products intended to be used for the insulation of buildings. The products covered by this standard are not intended to be used primarily for airborne sound insulation or sound absorption applications although they may improve the performance of the installation in these respects when installed for their primary insulation intended use.
Tämän julkaisun valmistelusta Suomessa vastaa Rakennustuoteteollisuus RTT ry, puh. 09 12 991 (vaihde).
EN 1097-3:1998 Tests for mechanical and physical properties of aggregates - Part 3: Determination of loose bulk density and voids
EN 12667:2001 Thermal performance of building materials and products - Determination of thermal resistance by means of guarded hot plate and heat flow meter methods - Products of high and medium thermal resistance
EN 13055:2016 Lightweight aggregates
EN 1097-3:1998 Tests for mechanical and physical properties of aggregates - Part 3: Determination of loose bulk density and voids
EN 12667:2001 Thermal performance of building materials and products - Determination of thermal resistance by means of guarded hot plate and heat flow meter methods - Products of high and medium thermal resistance
EN 13055:2016 Lightweight aggregates
EN 13172:2012 Thermal insulation products - Evaluation of conformity
EN 13820:2003 Thermal insulating materials for building applications - Determination of organic content
EN 14706:2012 Thermal insulating products for building equipment and industrial installations - Determination of maximum service temperature
EN 932-1:1996 Tests for general properties of aggregates - Part 1: Methods for sampling
EN 932-2:1999 Tests for general properties of aggregates - Part 2: Methods for reducing laboratory samples
EN 933-1:2012 Tests for geometrical properties of aggregates - Part 1: Determination of particle size distribution - Sieving method
EN ISO 13787:2003 Thermal insulation products for building equipment and industrial installations - Determination of declared thermal conductivity (ISO 13787:2003)
EN ISO 16535:2019 Thermal insulating products for building applications - Determination of long-term water absorption by immersion (ISO 16535:2019)
EN ISO 18097:2022 Thermal insulating products for building equipment and industrial installations - Determination of maximum service temperature (ISO 18097:2022)
EN ISO 8894-1:2010 Refractory materials - Determination of thermal conductivity - Part 1: Hot-wire methods (cross-array and resistance thermometer) (ISO 8894-1:2010)