Verkkokauppa
SFS-EN IEC 60904-2:2023:en
Photovoltaic devices - Part 2: Requirements for photovoltaic reference devices
Soveltamisala
Suomenkielistä soveltamisalaa ei ole saatavissa.
IEC 60904-2:2023 gives requirements for the classification, selection, packaging, marking, calibration and care of photovoltaic reference devices. This document applies to photovoltaic (PV) reference devices that are used to measure the irradiance of natural or simulated sunlight for the purpose of quantifying the electrical performance of photovoltaic devices (cells, modules and arrays). It does not cover photovoltaic reference devices for use under concentrated sunlight. This fourth edition cancels and replaces the third edition published in 2015. This edition includes the following significant technical changes with respect to the previous edition:
a) added calibration procedures for calibrating PV devices at maximum power by extending the respective Clauses 12 and 13;
b) revised requirements for mandatory measurement of spectral responsivity, temperature coefficients and linearity, depending on usage and allowing some measurements on equivalent devices;
c) revised requirements for built-in shunt resistor;
d) added requirements for traceability of calibration explicitly.
Tämän julkaisun valmistelusta Suomessa vastaa SESKO ry, puh. 050 571 6048.
IEC 60904-2:2023 gives requirements for the classification, selection, packaging, marking, calibration and care of photovoltaic reference devices. This document applies to photovoltaic (PV) reference devices that are used to measure the irradiance of natural or simulated sunlight for the purpose of quantifying the electrical performance of photovoltaic devices (cells, modules and arrays). It does not cover photovoltaic reference devices for use under concentrated sunlight. This fourth edition cancels and replaces the third edition published in 2015. This edition includes the following significant technical changes with respect to the previous edition:
a) added calibration procedures for calibrating PV devices at maximum power by extending the respective Clauses 12 and 13;
b) revised requirements for mandatory measurement of spectral responsivity, temperature coefficients and linearity, depending on usage and allowing some measurements on equivalent devices;
c) revised requirements for built-in shunt resistor;
d) added requirements for traceability of calibration explicitly.
Tämän julkaisun valmistelusta Suomessa vastaa SESKO ry, puh. 050 571 6048.
Tuoteryhmä(t)
Sidokset
Velvoittavat viittaukset
EN 60904-5:2011 Photovoltaic devices - Part 5: Determination of the equivalent cell temperature (ECT) of photovoltaic (PV) devices by the open-circuit voltage method
EN 60904-8:2014 Photovoltaic devices - Part 8: Measurement of spectral responsivity of a photovoltaic (PV) device
EN IEC 60891:2021 Aurinkosähkölaitteet. Mitattujen virta-jännite-ominaisuuksien lämpötilan ja säteilyolosuhteen korjausmenetelmät
EN 60904-8:2014 Photovoltaic devices - Part 8: Measurement of spectral responsivity of a photovoltaic (PV) device
EN IEC 60891:2021 Aurinkosähkölaitteet. Mitattujen virta-jännite-ominaisuuksien lämpötilan ja säteilyolosuhteen korjausmenetelmät
Tekninen komitea
Vahvistuspäivä
18.08.2023
Julkaisupäivä
22.08.2023
Painos
1
Sivumäärä
23
Julkaisun kieli
englanti