This document specifies the requirements for the design, installation and testing of cable over pulley steering systems on small craft with or without a propulsion engine(s), and on small craft with outboard engine(s) up to and including 37 kW total power. It specifies the requirements for the design and testing of all components of a cable over pulley steering system, from the steering mechanism to the mechanical interface with the rudder shaft or the outboard engine. It applies to cable over pulley steering systems, whether for pedestal or bulkhead types. This document does not address emergency means of steering the craft.
Tämän julkaisun valmistelusta Suomessa vastaa Metalliteollisuuden Standardisointiyhdistys ry, puh. 09 19 231 (vaihde).
Sisällysluettelo
Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 General requirements
5 Steering system requirements
6 Installation
7 Testing requirements
8 Owner’s manual
9 Instruction manual
Annex A Steering wheel and helm shaft fit (informative)
Annex B Recommended procedures for conducting cable over pulley strength tests as required in 7.2.2 for outboard engine applications — Tangential load test (informative)
Annex A Steering wheel and helm shaft fit (informative)
Annex B Recommended procedures for conducting cable over pulley strength tests as required in 7.2.2 for outboard engine applications — Tangential load test (informative)