Verkkokauppa
SFS-EN ISO 10724-2:en
Plastics. Injection moulding of test specimens of thermosetting powder moulding compounds (PMCs). Part 2: Small plates (ISO 10724-2:1998)
Soveltamisala
Suomenkielistä soveltamisalaa ei ole saatavissa.
This part of ISO 10724 specifies two two-cavity moulds, designated the type D1 and type D2 ISO moulds, for the injection moulding of small plates measuring 60 mm × 60 mm with preferred thicknesses of 1 mm (type D1) or 2 mm (type D2) which can be used for a variety of tests (see annex A). The moulds may additionally be fitted with inserts for studying the effects of weld lines on the mechanical properties (see annex B).
Tämän julkaisun valmistelusta Suomessa vastaa Kemesta ry, puh. 040 820 4888.
This part of ISO 10724 specifies two two-cavity moulds, designated the type D1 and type D2 ISO moulds, for the injection moulding of small plates measuring 60 mm × 60 mm with preferred thicknesses of 1 mm (type D1) or 2 mm (type D2) which can be used for a variety of tests (see annex A). The moulds may additionally be fitted with inserts for studying the effects of weld lines on the mechanical properties (see annex B).
Tämän julkaisun valmistelusta Suomessa vastaa Kemesta ry, puh. 040 820 4888.
Sisällysluettelo
Tuoteryhmä(t)
Sidokset
Velvoittavat viittaukset
ISO 10724-1:1998 Plastics -- Injection moulding of test specimens of thermosetting powder moulding compounds (PMCs) -- Part 1: General principles and moulding of multipurpose test specimens
ISO 2577:1984 Plastics -- Thermosetting moulding materials -- Determination of shrinkage
ISO 472:1999 Plastics -- Vocabulary
ISO 2577:1984 Plastics -- Thermosetting moulding materials -- Determination of shrinkage
ISO 472:1999 Plastics -- Vocabulary
Tekninen komitea
Vahvistuspäivä
29.01.2001
Julkaisupäivä
16.07.2001
Painos
1
Sivumäärä
17
Julkaisun kieli
englanti