ISO 10135:2007 specifies rules and conventions for the indications of requirements for moulded parts on technical product documentation. It also specifies the proportions and dimensions of the graphical symbols used for this representation.
Tämän julkaisun valmistelusta Suomessa vastaa Metalliteollisuuden Standardisointiyhdistys ry, puh. 09 19 231 (vaihde).
Sisällysluettelo
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Letter Symbols
5 Line conventions
6 Drawing indications for moulded parts
6.1 Parting surface
6.2 Tool markings
6.3 Special ejector markings identifier
6.4 Mismatch
6.5 Flash
6.6 Extent of specification
6.7 Draft angles
6.8 Tool motion direction
6.9 Part removal direction
6.10 Surface enlargement
6.11 Sinks
6.12 Porosity
6.13 Identification and marking
6.14 Other necessary information
6.15 Special indication for undisturbed surfaces
7 Rules for linear and geometrical dimensioning and tolerancing
7.1 Linear dimensioning and tolerancing
7.2 Geometrical tolerancing
7.3 Datums
7.4 Surface texture
7.5 Edges
Annex A Proportions and dimensions of graphical symbols (normative)
Annex B Former practice (tapered features) (informative)
Annex C Relation to the GPS matrix model (informative)
ISO 1101:2004 Geometrical Product Specifications (GPS) -- Geometrical tolerancing -- Tolerances of form, orientation, location and run-out
ISO 128-22:1999 Technical drawings -- General principles of presentation -- Part 22: Basic conventions and applications for leader lines and reference lines
ISO 128-24:1999 Technical drawings -- General principles of presentation -- Part 24: Lines on mechanical engineering drawings
ISO 1101:2004 Geometrical Product Specifications (GPS) -- Geometrical tolerancing -- Tolerances of form, orientation, location and run-out
ISO 128-22:1999 Technical drawings -- General principles of presentation -- Part 22: Basic conventions and applications for leader lines and reference lines
ISO 128-24:1999 Technical drawings -- General principles of presentation -- Part 24: Lines on mechanical engineering drawings
ISO 129-1:2004 Technical drawings -- Indication of dimensions and tolerances -- Part 1: General principles
ISO 1302:2002 Geometrical Product Specifications (GPS) -- Indication of surface texture in technical product documentation
ISO 13715:2000 Technical drawings -- Edges of undefined shape -- Vocabulary and indications
ISO 14660-1:1999 Geometrical Product Specifications (GPS) -- Geometrical features -- Part 1: General terms and definitions
ISO 14660-2:1999 Geometrical Product Specifications (GPS) -- Geometrical features -- Part 2: Extracted median line of a cylinder and a cone, extracted median surface, local size of an extracted feature
ISO 2692:2006 Geometrical product specifications (GPS) -- Geometrical tolerancing -- Maximum material requirement (MMR), least material requirement (LMR) and reciprocity requirement (RPR)
ISO 406:1987 Technical drawings -- Tolerancing of linear and angular dimensions
ISO 5459:1981 Technical drawings -- Geometrical tolerancing -- Datums and datum-systems for geometrical tolerances
ISO 7083:1983 Technical drawings -- Symbols for geometrical tolerancing -- Proportions and dimensions
ISO 8062-1:2007 Geometrical product specifications (GPS) -- Dimensional and geometrical tolerances for moulded parts -- Part 1: Vocabulary
ISO 81714-1:1999 Design of graphical symbols for use in the technical documentation of products -- Part 1: Basic rules
ISO 8785:1998 Geometrical Product Specification (GPS) -- Surface imperfections -- Terms, definitions and parameters
ISO/TR 14638:1995 Geometrical product specification (GPS) -- Masterplan