This International Standard specifies a method to determine the flash point of paints, varnishes, paint binders, solvents, petroleum or related products. This International Standard is not applicable to water-borne paints which may, however, be tested using ISO 3679. The method is suitable for use over the temperature range - 30 °C to 110 °C, depending on the use of different apparatus listed in Table 1. The interpretation of results obtained from solvent mixtures containing halogenated hydrocarbons should be considered with caution, as these mixtures can give anomalous results.
Tämän julkaisun valmistelusta Suomessa vastaa SFS Suomen Standardit, puh. 09 149 9331.
Sisällysluettelo
Foreword
Introduction
1 Scope
2 Normative references
3 Term and definition
4 Principle
5 Chemicals and materials
6 Apparatus
7 Apparatus preparation
7.1 Location of the apparatus
7.2 Preparation of the heating bath
7.3 Preparation of the test cup
7.4 Apparatus verification
8 Sampling
9 Sample handling
9.1 Petroleum products
9.2 Paints and varnishes
9.3 Samples to be tested at a temperature below ambient
ASTM D 56:2000 Standard Test Method for Flash Point by Tag Closed Tester
DIN 51755:1974
ISO 13736:1997 Petroleum products and other liquids -- Determination of flash point -- Abel closed cup method
ASTM D 56:2000 Standard Test Method for Flash Point by Tag Closed Tester
DIN 51755:1974
ISO 13736:1997 Petroleum products and other liquids -- Determination of flash point -- Abel closed cup method
ISO 1513:1992 Paints and varnishes -- Examination and preparation of samples for testing
ISO 15528:2000 Paints, varnishes and raw materials for paints and varnishes -- Sampling
ISO 2719:2002 Determination of flash point -- Pensky-Martens closed cup method
ISO 3170:1988 Petroleum liquids -- Manual sampling
ISO 3171:1988 Petroleum liquids -- Automatic pipeline sampling