ISO 4414:2010 specifies general rules and safety requirements for pneumatic fluid power systems and components used on machinery as defined by ISO 12100. ISO 4414:2010 deals with all significant hazards associated with pneumatic fluid power systems and specifies principles to apply in order to avoid those hazards when the systems are put to their intended use. ISO 4414:2010 applies to the design, construction and modification of systems and their components, also taking into account the following aspects: assembly, installation, adjustment, uninterrupted system operation, ease and economy of maintenance and cleaning, reliable operation in all intended uses, energy efficiency and environment. ISO 4414:2010 does not apply to air compressors and the systems associated with air distribution as typically installed in a factory, including gas bottles and receivers.
Tämän julkaisun valmistelusta Suomessa vastaa Metalliteollisuuden Standardisointiyhdistys ry, puh. 09 19 231 (vaihde).
Sisällysluettelo
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 List of significant hazards
5 General rules and safety requirements
5.1 General
5.2 Basic requirements for the design and specification of pneumatic systems
5.3 Additional requirements
5.4 Specific requirements for components and controls
6 Verification of safety requirements and acceptance testing
7 Information for use
7.1 General requirements
7.2 Final information
7.3 Maintenance and operating data
7.4 Marking and identification
8 Identification statement (reference to this International Standard)
Annex A List of significant hazards (informative)
Annex B Form for collecting pneumatic system and component data to ensure conformance with ISO 4414 (informative)
IEC 60529:1989
ISO 11727:1999 Pneumatic fluid power -- Identification of ports and control mechanisms of control valves and other components
ISO 1211:2010 Milk -- Determination of fat content -- Gravimetric method (Reference method)
IEC 60529:1989
ISO 11727:1999 Pneumatic fluid power -- Identification of ports and control mechanisms of control valves and other components
ISO 1211:2010 Milk -- Determination of fat content -- Gravimetric method (Reference method)
ISO 1219-1:2006 Fluid power systems and components -- Graphic symbols and circuit diagrams -- Part 1: Graphic symbols for conventional use and data-processing applications
ISO 1219-2:1995 Fluid power systems and components -- Graphic symbols and circuit diagrams -- Part 2: Circuit diagrams
ISO 13850:2006 Safety of machinery -- Emergency stop -- Principles for design
ISO 13851:2002 Safety of machinery -- Two-hand control devices -- Functional aspects and design principles
ISO 14118:2000 Safety of machinery -- Prevention of unexpected start-up
ISO 5598:2008 Fluid power systems and components -- Vocabulary