Chemical analysis of ferrous materials. Inductively coupled plasma optical emission spectrometric analysis of unalloyed and low alloyed steels. Determination of Mn, P, Cu, Ni, Cr, Mo, V, Co, Al (total) and Sn [Routine method]
Tuote ladattavissa hetiToimitusaika on noin 1 - 2 työpäivääToimitusaika on 3 - 5 työpäivää.
This European Standard specifies an inductively coupled plasma optical emission spectrometry routine method for the analysis of unalloyed and low alloyed steels, whose iron content shall be at least 95 %. This method is applicable to the elements listed in Table 1 within the ranges shown. Table 1 - Application ranges (...) In all cases, the ranges specified can be extended or adapted (after validation) for the determination of other mass fractions, provided that the iron content in the samples under concern is above 95 %. Other elements may be included. However such elements and their mass fractions should be carefully checked, taking into account the possible interferences, the sensitivity, the resolution and the linearity criteria of each instrument and each wavelength. Depending also on the sensitivity of each instrument, suitable dilutions of the calibration and the test sample solutions may be necessary. Moreover, even if the method described is "multi elemental", it is not absolutely necessary to carry out the determination of all the elements of its scope simultaneously: the measurement conditions have to be optimised by each laboratory, depending on the performances of each apparatus available. NOTE 1 The accuracy of the method is unsatisfactory for phosphorus contents from 0,05 to 0,1 %. NOTE 2 The trueness of the method couldn't be checked for vanadium contents below 0,05 %. NOTE 3 The precision of the method is unsatisfactory for aluminium (total) contents below 0,02 %.
Tämän julkaisun valmistelusta Suomessa vastaa Metalliteollisuuden Standardisointiyhdistys ry, puh. 09 19 231 (vaihde).
CEN/TR 10345:2008 Guideline for statistical data treatment of inter laboratory tests for validation of analytical methods
EN ISO 14284:2002 Steel and iron - Sampling and preparation of samples for the determination of chemical composition (ISO 14284:1996)
EN ISO 14284:2022 Steel and iron - Sampling and preparation of samples for the determination of chemical composition (ISO 14284:2022)
CEN/TR 10345:2008 Guideline for statistical data treatment of inter laboratory tests for validation of analytical methods
EN ISO 14284:2002 Steel and iron - Sampling and preparation of samples for the determination of chemical composition (ISO 14284:1996)
EN ISO 14284:2022 Steel and iron - Sampling and preparation of samples for the determination of chemical composition (ISO 14284:2022)
ISO 1042:1998 Laboratory glassware -- One-mark volumetric flasks
ISO 5725-1:1994 Accuracy (trueness and precision) of measurement methods and results -- Part 1: General principles and definitions
ISO 5725-2:1994 Accuracy (trueness and precision) of measurement methods and results -- Part 2: Basic method for the determination of repeatability and reproducibility of a standard measurement method
ISO 5725-3:1994 Accuracy (trueness and precision) of measurement methods and results -- Part 3: Intermediate measures of the precision of a standard measurement method
ISO 648:2008 Laboratory glassware -- Single-volume pipettes