Non-destructive testing of steel tubes. Part 10: Automated full peripheral ultrasonic testing of seamless and welded (except submerged arc-welded) steel tubes for the detection of longitudinal and/or transverse imperfections (ISO 10893-10:2011)
Tuote ladattavissa hetiToimitusaika on noin 1 - 2 työpäivääToimitusaika on 3 - 5 työpäivää.
ISO 10893-10:2011 specifies requirements for automated full peripheral ultrasonic shear wave (generated by conventional or phased array technique) testing of seamless and welded [except submerged arc-welded (SAW)] steel tubes, for the detection of longitudinal and/or transverse imperfections. In the case of testing on longitudinal imperfections, Lamb wave testing can be applied at the discretion of the manufacturer. For seamless tubes, by agreement between the purchaser and manufacturer, testing principles of ISO 10893-10:2011 can be applied to detect imperfections having other orientations. ISO 10893-10:2011 is applicable to the inspection of tubes with an outside diameter greater than or equal to 10 mm, normally with an outside diameter-to-thickness ratio greater than or equal to 5. It can also be applicable to the testing of circular hollow sections.
Tämän julkaisun valmistelusta Suomessa vastaa Metalliteollisuuden Standardisointiyhdistys ry, puh. 09 19 231 (vaihde).
Sisällysluettelo
Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 General requirements
5 Test method
6 Reference tube
6.1 General
6.2 Types of reference notches
6.3 Dimensions of reference notches
7 Equipment calibration and checking
7.1 General
7.2 Adjustment of trigger/alarm level
7.3 Calibration check and recalibration
8 Acceptance
9 Test report
Annex A Testing on longitudinal imperfections of tubes with a ratio of the specified outside diameter to the average of the specified thickness range less than 5 (normative)
Annex B Manual/semi-automated testing of untested ends and suspect areas (normative)
Annex A Testing on longitudinal imperfections of tubes with a ratio of the specified outside diameter to the average of the specified thickness range less than 5 (normative)
Annex B Manual/semi-automated testing of untested ends and suspect areas (normative)
ISO 11484:2009 Steel products -- Employer's qualification system for non-destructive testing (NDT) personnel
ISO 5577:2000 Non-destructive testing -- Ultrasonic inspection -- Vocabulary
ISO 9712:2005 Non-destructive testing -- Qualification and certification of personnel
ISO 11484:2009 Steel products -- Employer's qualification system for non-destructive testing (NDT) personnel
ISO 5577:2000 Non-destructive testing -- Ultrasonic inspection -- Vocabulary
ISO 9712:2005 Non-destructive testing -- Qualification and certification of personnel