Standardin ISO 9445 tässä osassa esitetään mitta- ja muototoleranssit kylmävalssatuille ruostumattomille leveille teräsnauhoille ja levyille, joiden paksuus on 0,30…8,0 mm ja valssausleveys 600…2 100 mm. Standardi koskee myös kylmävalssatusta leveästä nauhasta pituussuuntaisesti halkaistuja kapeita nauhoja, joiden leveys on alle 600 mm sekä niistä leikattuja levyjä.
Tämän julkaisun valmistelusta Suomessa vastaa Metalliteollisuuden Standardisointiyhdistys ry, puh. 09 19 231 (vaihde).
Sisällysluettelo
Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Information to be supplied by the purchaser
5 Type of delivery and delivery condition
5.1 General
5.2 Type of delivery
5.3 Delivery condition of cold-rolled wide strip and products obtained from cold-rolled wide strip
6 Preferred thicknesses
7 Tolerances on thickness for cold-rolled wide strip and products obtained from cold-rolled wide strip
8 Tolerances on width for cold-rolled wide strip and products obtained from cold-rolled wide strip
9 Preferred coil inner diameters for cold-rolled wide strip and slit cold-rolled wide strip
10 Tolerances on length for plate/sheet cut from cold-rolled wide strip and for cut lengths obtained from slit cold-rolled wide strip
11 Tolerances on edge camber for cold-rolled wide strip and products obtained from cold-rolled wide strip
12 Tolerances on squareness for plate/sheet obtained from cold-rolled wide strip and cut lengths obtained from slit cold-rolled wide strip
13 Tolerances on flatness for plate/sheet obtained from cold-rolled wide strip and cut lengths obtained from slit cold-rolled wide strip
14 Edge waviness tolerances for cold-rolled strip
15 Form of coils
16 Ordered format for plate/sheet and cut lengths
17 Measurement of thickness for cold-rolled wide strip, plate/sheet cut from cold-rolled wide strip, slit cold-rolled wide strip and cut lengths obtained from slit cold-rolled wide strip