ISO 13088:2011 specifies the minimum requirements for the filling conditions and filling inspection of acetylene cylinder bundles. It applies both to both bundles which are filled while the cylinders are assembled in the bundle and to bundles of which the cylinders are filled as individual cylinders and are assembled into a bundle after filling. It does not apply to bundles containing solvent-free acetylene cylinders. ISO 13088:2011 is not applicable to individual acetylene cylinders that are not intended to be assembled into a bundle (see ISO 11372).
Tämän julkaisun valmistelusta Suomessa vastaa Kemesta ry, puh. 040 820 4888.
Sisällysluettelo
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Basic requirements for acetylene cylinder bundles
4.1 General
4.2 Filling conditions
5 Assembly, marking and documentation of acetylene cylinder bundles
5.1 Assembly
5.2 Verification of marking and necessary documentation
5.3 Documentation
6 Filling inspection for acetylene cylinder bundles
6.1 Pre-fill inspection
6.2 Solvent content
6.3 Number of consecutive fillings
6.4 Inspection during filling
6.5 Post-fill inspection
7 Individual filling of acetylene bundle cylinders
Annex A Procedure for establishing the filling conditions of acetylene cylinder bundles (normative)
Annex B Determination of the solvent content in the bundle in the course of the filling inspection (normative)