Stationary source emissions. Determination of the ratio of biomass (biogenic) and fossil-derived carbon dioxide. Radiocarbon sampling and determination (ISO 13833:2013)
Tuote ladattavissa hetiToimitusaika on noin 1 - 2 työpäivääToimitusaika on 3 - 5 työpäivää.
ISO 13833:2013 specifies sampling methods and analysis methods for the determination of the ratio of biomass- and fossil-derived carbon dioxide (CO2) in the CO2 from exhaust gases of stationary sources, based on the radiocarbon (14C isotope) method. The lower limit of application is a biogenic to total CO2 fraction of 0,02. The working range is a biogenic to total CO2 fraction of 0,02 to 1,0.
Tämän julkaisun valmistelusta Suomessa vastaa SFS Suomen Standardit, puh. 09 149 9331.
Sisällysluettelo
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and abbreviated terms
4.1 Symbols
4.2 Abbreviations
5 Principle
5.1 General
5.2 Principles of sampling
5.3 14C measurement techniques
6 Reagent, materials and equipment
7 Analysis
8 Calculation of the results
9 Quality assurance and quality control procedures
10 Test report
Annex A Procedure for 14C determination by accelerator mass spectrometry (normative)
Annex B Procedure for 14C determination by liquid scintillation counter method (normative)
Annex C Procedures for 14C determination by beta-ionization (normative)
Annex D Performance characteristics 14C methods (informative)
Annex E Definitions and equations of the 14C-based method (informative)
ISO 10396:2007 Stationary source emissions -- Sampling for the automated determination of gas emission concentrations for permanently-installed monitoring systems
ISO 15713:2006 Stationary source emissions -- Sampling and determination of gaseous fluoride content
ISO 7934:1989 Stationary source emissions -- Determination of the mass concentration of sulfur dioxide -- Hydrogen peroxide/barium perchlorate/Thorin method
ISO 10396:2007 Stationary source emissions -- Sampling for the automated determination of gas emission concentrations for permanently-installed monitoring systems
ISO 15713:2006 Stationary source emissions -- Sampling and determination of gaseous fluoride content
ISO 7934:1989 Stationary source emissions -- Determination of the mass concentration of sulfur dioxide -- Hydrogen peroxide/barium perchlorate/Thorin method