ISO 15874-5:2013 specifies the characteristics of the fitness for purpose of polypropylene (PP) piping systems, intended to be used for hot and cold water installations within buildings for the conveyance of water, whether or not intended for human consumption (domestic systems) and for heating systems, under design pressures and temperatures according to the class of application. It covers a range of service conditions (classes of application) and design pressure classes. It also specifies test parameters for test methods. In conjunction with the other parts of ISO 15874, it is applicable to PP pipes, fittings, their joints and to joints with components of other plastics and non-plastics materials intended to be used for hot and cold water installations.
Tämän julkaisun valmistelusta Suomessa vastaa Muoviteollisuus ry, puh. 09 172 841 (vaihde).
Sisällysluettelo
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions, symbols and abbreviated terms
4 Fitness for purpose of the joints and the piping system
ISO 1167-1:2006 Thermoplastics pipes, fittings and assemblies for the conveyance of fluids -- Determination of the resistance to internal pressure -- Part 1: General method
ISO 1167-2:2006 Thermoplastics pipes, fittings and assemblies for the conveyance of fluids -- Determination of the resistance to internal pressure -- Part 2: Preparation of pipe test pieces
ISO 1167-3:2007 Thermoplastics pipes, fittings and assemblies for the conveyance of fluids -- Determination of the resistance to internal pressure -- Part 3: Preparation of components
ISO 1167-1:2006 Thermoplastics pipes, fittings and assemblies for the conveyance of fluids -- Determination of the resistance to internal pressure -- Part 1: General method
ISO 1167-2:2006 Thermoplastics pipes, fittings and assemblies for the conveyance of fluids -- Determination of the resistance to internal pressure -- Part 2: Preparation of pipe test pieces
ISO 1167-3:2007 Thermoplastics pipes, fittings and assemblies for the conveyance of fluids -- Determination of the resistance to internal pressure -- Part 3: Preparation of components
ISO 1167-4:2007 Thermoplastics pipes, fittings and assemblies for the conveyance of fluids -- Determination of the resistance to internal pressure -- Part 4: Preparation of assemblies
ISO 13056:2011 Plastics piping systems -- Pressure systems for hot and cold water -- Test method for leaktightness under vacuum
ISO 15874-1:2013 Plastics piping systems for hot and cold water installations -- Polypropylene (PP) -- Part 1: General
ISO 15874-2:2013 Plastics piping systems for hot and cold water installations -- Polypropylene (PP) -- Part 2: Pipes
ISO 19892:2011 Plastics piping systems -- Thermoplastics pipes and fittings for hot and cold water -- Test method for the resistance of joints to pressure cycling
ISO 19893:2011 Plastics piping systems -- Thermoplastics pipes and fittings for hot and cold water -- Test method for the resistance of mounted assemblies to temperature cycling
ISO 3501:2015 Plastics piping systems -- Mechanical joints between fittings and pressure pipes -- Test method for resistance to pull-out under constant longitudinal force
ISO 3503:2015 Plastics piping systems -- Mechanical joints between fittings and pressure pipes -- Test method for leaktightness under internal pressure of assemblies subjected to bending