Verkkokauppa
CEN/TS 16490:en
Fertilizers. Comparison of the CEN/TC 260/WG 7 ring test results with tolerances given in the Regulation (EC) Nr 2003/2003 Annex II and conclusions
Soveltamisala
Suomenkielistä soveltamisalaa ei ole saatavissa.
In Regulation (EC) No. 2003/2003 [2] tolerance limits are mentioned for nutrient contents in mineral fertilizers (Annex II of Regulation (EC) No. 2003/2003) as well as prescribed methods for control purposes (Annex IV of Regulation (EC) No. 2003/2003).
Prior to the work done by CEN/TC 260 following Mandate M/335, no statistical data were available for the official analytical methods to be applied. Due to the standardization work done for this mandate, statistical data have been generated as ring testing was a major topic in this mandate.
This Technical Specification describes to what extent the presently applied tolerances are in line with the obtained precision data from the analytical methods studied.
The purpose of this document is to give feedback on the applied tolerances within Regulation (EC) No. 2003/2003 based on the method evaluation done as an outcome of the work executed by CEN/TC 260/WG 7 according to Mandate M/335. This evaluation of the tolerances was part of Mandate M/418.
Tämän julkaisun valmistelusta Suomessa vastaa Kemesta ry, puh. 040 820 4888.
In Regulation (EC) No. 2003/2003 [2] tolerance limits are mentioned for nutrient contents in mineral fertilizers (Annex II of Regulation (EC) No. 2003/2003) as well as prescribed methods for control purposes (Annex IV of Regulation (EC) No. 2003/2003).
Prior to the work done by CEN/TC 260 following Mandate M/335, no statistical data were available for the official analytical methods to be applied. Due to the standardization work done for this mandate, statistical data have been generated as ring testing was a major topic in this mandate.
This Technical Specification describes to what extent the presently applied tolerances are in line with the obtained precision data from the analytical methods studied.
The purpose of this document is to give feedback on the applied tolerances within Regulation (EC) No. 2003/2003 based on the method evaluation done as an outcome of the work executed by CEN/TC 260/WG 7 according to Mandate M/335. This evaluation of the tolerances was part of Mandate M/418.
Tämän julkaisun valmistelusta Suomessa vastaa Kemesta ry, puh. 040 820 4888.
Tuoteryhmä(t)
Sidokset
Velvoittavat viittaukset
ISO 5725-1:1994 Accuracy (trueness and precision) of measurement methods and results -- Part 1: General principles and definitions
Tekninen komitea
Vahvistuspäivä
20.05.2013
Julkaisupäivä
07.06.2013
Painos
1
Sivumäärä
35
Julkaisun kieli
englanti