This European Standard specifies requirements for adaptors and connectors made from vitrified clay and/or other suitable materials for use with vitrified clay pipes and fittings for buried drain and sewer systems for the conveyance of wastewater (including domestic wastewater, surface water and rainwater) under gravity and periodic hydraulic surcharge or under continuous low head of pressure. Adaptors and connectors include insertable fittings, sealing rings for cut pipes and heat-shrinkable sleeves. This standard also applies for metal banded flexible couplings and adaptors and specifies requirements for rubber, polyurethane, stainless steel and other components used for them. NOTE 1 The specifiers/purchasers can select adaptors, connectors and flexible couplings according to their requirements. NOTE 2 Corresponding provisions for the evaluation of conformity (ITT and FPC) and sampling and those for the test methods are further specified in EN 295 2 and EN 295 3, respectively.
Tämän julkaisun valmistelusta Suomessa vastaa Metalliteollisuuden Standardisointiyhdistys ry, puh. 09 19 231 (vaihde).
EN 10088-2:2005 Stainless steels - Part 2: Technical delivery conditions for sheet/plate and strip of corrosion resisting steels for general purposes
EN 1427:2015 Bitumen and bituminous binders - Determination of the softening point - Ring and Ball method
EN 295-1:2013 Vitrified clay pipe systems for drains and sewers - Part 1: Requirements for pipes, fittings and joints
EN 10088-2:2005 Stainless steels - Part 2: Technical delivery conditions for sheet/plate and strip of corrosion resisting steels for general purposes
EN 1427:2015 Bitumen and bituminous binders - Determination of the softening point - Ring and Ball method
EN 295-1:2013 Vitrified clay pipe systems for drains and sewers - Part 1: Requirements for pipes, fittings and joints
EN 295-3:2012 Vitrified clay pipe systems for drains and sewers - Part 3: Test methods
EN 295-5:2013 Vitrified clay pipe systems for drains and sewers - Part 5: Requirements for perforated pipes and fittings
EN 295-6:2013 Vitrified clay pipes systems for drain and sewers - Part 6: Requirements for components of manholes and inspection chambers
EN 295-7:2013 Vitrified clay pipe systems for drains and sewers - Part 7: Requirements for pipes and joints for pipe jacking
EN 681-1:1996 Elastomeric seals - Materials requirements for pipe joint seals used in water and drainage applications - Part 1: Vulcanized rubber
EN ISO 1183-1:2019 Plastics - Methods for determining the density of non-cellular plastics - Part 1: Immersion method, liquid pycnometer method and titration method (ISO 1183-1:2019, Corrected version 2019-05)
EN ISO 527-1:2019 Plastics - Determination of tensile properties - Part 1: General principles (ISO 527-1:2019)
EN ISO 527-2:2012 Plastics - Determination of tensile properties - Part 2: Test conditions for moulding and extrusion plastics (ISO 527-2:2012)
EN ISO 868:2003 Plastics and ebonite - Determination of indentation hardness by means of a durometer (Shore hardness) (ISO 868:2003)
EN ISO 9445-1:2010 Continuously cold-rolled stainless steel - Tolerances on dimensions and form - Part 1: Narrow strip and cut lengths (ISO 9445-1:2009)
ISO 3302-1:1996 Rubber -- Tolerances for products -- Part 1: Dimensional tolerances
ISO 4587:2003 Adhesives -- Determination of tensile lap-shear strength of rigid-to-rigid bonded assemblies