Safety of machinery. Pressure-sensitive protective devices. Part 3: General principles for design and testing of pressure-sensitive bumpers, plates, wires and similar devices (ISO 13856-3:2013)
Tuote ladattavissa hetiToimitusaika on noin 1 - 2 työpäivääToimitusaika on 3 - 5 työpäivää.
ISO 13856-3:2013 establishes general principles and specifies requirements for the design and testing of those pressure-sensitive protective devices, with or without an external reset facility, that are not specified in either ISO 13856-1 or ISO 13856-2, and the majority of which are produced for specific applications and are not available as "off-the-shelf" items. ISO 13856-3:2013 also gives specific requirements for the following pressure-sensitive protective devices: pressure-sensitive bumpers; pressure-sensitive plates; pressure-sensitive wires (trip wires). It deals with the design of a pressure-sensitive device with regard to safety and reliability rather than its suitability for particular applications. It is not applicable to specifying the dimensions of pressure-sensitive protective devices in relation to any particular application, or stopping devices according to IEC 60204-1 used for the normal operation, including emergency stopping of machinery. While requirements are given for the immunity of the device to electromagnetic disturbances, these are not intended to cover all aspects of electromagnetic compatibility (EMC).
Tämän julkaisun valmistelusta Suomessa vastaa Metalliteollisuuden Standardisointiyhdistys ry, puh. 09 19 231 (vaihde).
Sisällysluettelo
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Requirements for design and testing
4.1 General
4.2 Basic requirements
4.3 Specific requirements for pressure-sensitive bumpers
4.4 Specific requirements for pressure-sensitive plates
4.5 Specific requirements for pressure-sensitive wires (trip wires)
5 Marking
5.1 General
5.2 Labels
5.3 Marking of the control unit
5.4 Marking of the sensor
6 Information for selection and use
6.1 General
6.2 Essential data for selection of suitable pressure-sensitive protective device
6.3 Information for use
7 Verification of requirements
7.1 Verification of requirements applicable to all pressure-sensitive protective devices covered by this part of ISO 13856
7.2 Verification of requirements for pressure-sensitive bumpers only
7.3 Verification of requirements for pressure-sensitive plates only
7.4 Verification of requirements for pressure-sensitive wires only
7.5 Other tests
Annex A Timing diagrams for pressure-sensitive bumpers, plates, wires and similar devices with/without reset (normative)
Annex B Device characteristics — Explanatory remarks and recommendations (informative)
Annex C Design guidance (informative)
Annex D Application guidance (informative)
Annex E Commissioning and inspection (informative)