Agricultural and forestry machinery. Environmental requirements for sprayers. Part 2: Horizontal boom sprayers (ISO 16119-2:2013, Corrected version 2017-03)
Tuote ladattavissa hetiToimitusaika on noin 1 - 2 työpäivääToimitusaika on 3 - 5 työpäivää.
ISO 16119-2:2013 specifies requirements and the means for their verification for the design and performance of horizontal boom sprayers, as defined in 3.1, with regard to minimizing the potential risk of environmental contamination during use, including misuse foreseeable by the manufacturer. It is intended to be used with ISO 16119-1, which gives general requirements common to all the sprayer types covered by ISO 16119. It does not cover safety aspects (see ISO 4254-6). ISO 16119-2:2013 is not applicable to sprayers manufactured before the date of its publication.
Tämän julkaisun valmistelusta Suomessa vastaa Metalliteollisuuden Standardisointiyhdistys ry, puh. 09 19 231 (vaihde).
Sisällysluettelo
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 List of significant hazards
5 Requirements
5.1 General
5.2 Volume/hectare adjustment system
5.3 Distribution and control of spray drift
5.4 Cleaning
5.5 Cleaning devices
5.6 Additional requirements for band sprayers
5.7 Additional requirements for spray guns and lances
ISO 13440:1996 Equipment for crop protection -- Agricultural sprayers -- Determination of the volume of total residual
ISO 16119-1:2013 Agricultural and forestry machinery -- Environmental requirements for sprayers -- Part 1: General
ISO 21278-1:2008 Equipment for crop protection -- Induction hoppers -- Part 1: Test methods
ISO 13440:1996 Equipment for crop protection -- Agricultural sprayers -- Determination of the volume of total residual
ISO 16119-1:2013 Agricultural and forestry machinery -- Environmental requirements for sprayers -- Part 1: General
ISO 21278-1:2008 Equipment for crop protection -- Induction hoppers -- Part 1: Test methods
ISO 21278-2:2008 Equipment for crop protection -- Induction hoppers -- Part 2: General requirements and performance limits
ISO 22368-1:2004 Crop protection equipment -- Test methods for the evaluation of cleaning systems -- Part 1: Internal cleaning of complete sprayers
ISO 22368-3:2004 Crop protection equipment -- Test methods for the evaluation of cleaning systems -- Part 3: Internal cleaning of tank
ISO 22369-2:2010 Crop protection equipment -- Drift classification of spraying equipment -- Part 2: Classification of field crop sprayers by field measurements
ISO 22856:2008 Equipment for crop protection -- Methods for the laboratory measurement of spray drift -- Wind tunnels
ISO 22866:2005 Equipment for crop protection -- Methods for field measurement of spray drift
ISO 4102:1984 Equipment for crop protection -- Sprayers -- Connection threading
ISO 4254-6:2009 Agricultural machinery -- Safety -- Part 6: Sprayers and liquid fertilizer distributors
ISO 4288:1996 Geometrical Product Specifications (GPS) -- Surface texture: Profile method -- Rules and procedures for the assessment of surface texture
ISO 5681:1992 Equipment for crop protection -- Vocabulary
ISO 5682-1:1996 Equipment for crop protection -- Spraying equipment -- Part 1: Test methods for sprayer nozzles
ISO 5682-2:1997 Equipment for crop protection -- Spraying equipment -- Part 2: Test methods for hydraulic sprayers
ISO 5682-3:1996 Equipment for crop protection -- Spraying equipment -- Part 3: Test method for volume/hectare adjustment systems of agricultural hydraulic pressure sprayers
ISO 9357:1990 Equipment for crop protection -- Agricultural sprayers -- Tank nominal volume and filling hole diameter