ISO 16810:2012 defines the general principles required for the ultrasonic examination of industrial products that permit the transmission of ultrasound. The specific conditions of application and use of ultrasonic examination, which depend on the type of product examined, are described in documents which could include: a) product standards; b) specifications; c) codes; d) contractual documents; e) written procedures. Unless otherwise specified in the referencing documents the minimum requirements of ISO 16810:2012 are applicable. ISO 16810:2012 does not define: 1) extent of examination and scanning plans; 2) acceptance criteria.
Tämän julkaisun valmistelusta Suomessa vastaa Metalliteollisuuden Standardisointiyhdistys ry, puh. 09 19 231 (vaihde).
Sisällysluettelo
Foreword
Introduction
1 Scope
2 Normative references
3 Qualification and certification of personnel
4 Information required prior to examination
5 Principles of ultrasonic examination
5.1 General
5.2 Vibration mode and direction of sound propagation
EN ISO 22232-1:2020 Non-destructive testing - Characterization and verification of ultrasonic test equipment - Part 1: Instruments (ISO 22232-1:2020)
EN ISO 22232-2:2020 Non-destructive testing - Characterization and verification of ultrasonic test equipment - Part 2: Probes (ISO 22232-2:2020)
EN ISO 22232-3:2020 Non-destructive testing - Characterization and verification of ultrasonic test equipment - Part 3: Combined equipment (ISO 22232-3:2020)
EN ISO 22232-1:2020 Non-destructive testing - Characterization and verification of ultrasonic test equipment - Part 1: Instruments (ISO 22232-1:2020)
EN ISO 22232-2:2020 Non-destructive testing - Characterization and verification of ultrasonic test equipment - Part 2: Probes (ISO 22232-2:2020)
EN ISO 22232-3:2020 Non-destructive testing - Characterization and verification of ultrasonic test equipment - Part 3: Combined equipment (ISO 22232-3:2020)
ISO 16811:2012 Non-destructive testing -- Ultrasonic testing -- Sensitivity and range setting
ISO 16823:2012 Non-destructive testing -- Ultrasonic testing -- Transmission technique
ISO 2400:2012 Non-destructive testing -- Ultrasonic testing -- Specification for calibration block No. 1
ISO 7963:2006 Non-destructive testing -- Ultrasonic testing --- Specification for calibration block No. 2
ISO 9712:2012 Non-destructive testing -- Qualification and certification of NDT personnel