Geometrical product specifications (GPS). Inspection by measurement of workpieces and measuring equipment. Part 5: Uncertainty in verification testing of indicating measuring instruments (ISO 14253-5:2015)
Tuote ladattavissa hetiToimitusaika on noin 1 - 2 työpäivääToimitusaika on 3 - 5 työpäivää.
ISO 14253-5:2015 specifies concepts and terms for evaluating the uncertainties of the test values derived according to a test protocol agreed upon by the parties and relative to instrument indication(s), obtained in verification testing of GPS indicating measuring instruments. NOTE The uncertainty of the test values, referred to as test value uncertainty, is not to be confused with the measurement uncertainty associated with using that indicating measuring instrument to measure workpieces. The former only is covered in this part of ISO 14253; for guidance on the latter see the ISO/IEC Guide 98-3 (GUM) and ISO 14253-2. When a test of an indicating measuring instrument comprises several test values, some relative to the instrument indication and some to other metrological characteristics, this part of ISO 14253 is concerned with the uncertainty of the former only. This part of ISO 14253 does not provide guidelines to ensure the adequacy of a test protocol; rather, once a test protocol is given, it describes how to evaluate the consequent test value uncertainty.
Tämän julkaisun valmistelusta Suomessa vastaa Metalliteollisuuden Standardisointiyhdistys ry, puh. 09 19 231 (vaihde).
Sisällysluettelo
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 General
5 Test measurand
5.1 General
5.2 Input quantities and test measurand definition
6 Tester responsibility criterion
7 Specific issues in testing indicating measuring instruments
7.1 General
7.2 Errors of the indicating measuring instrument
7.3 Errors in user-provided quantity values
7.4 Using alternative test equipment
Annex A Guidance on using alternative test equipment (informative)
Annex B Relation to the GPS matrix model (informative)
ISO 10360-1:2000 Geometrical Product Specifications (GPS) -- Acceptance and reverification tests for coordinate measuring machines (CMM) -- Part 1: Vocabulary
ISO 14253-1:2013 Geometrical product specifications (GPS) -- Inspection by measurement of workpieces and measuring equipment -- Part 1: Decision rules for proving conformity or nonconformity with specifications
ISO 14978:2006 Geometrical product specifications (GPS) -- General concepts and requirements for GPS measuring equipment
ISO 10360-1:2000 Geometrical Product Specifications (GPS) -- Acceptance and reverification tests for coordinate measuring machines (CMM) -- Part 1: Vocabulary
ISO 14253-1:2013 Geometrical product specifications (GPS) -- Inspection by measurement of workpieces and measuring equipment -- Part 1: Decision rules for proving conformity or nonconformity with specifications
ISO 14978:2006 Geometrical product specifications (GPS) -- General concepts and requirements for GPS measuring equipment
ISO 17450-2:2012 Geometrical product specifications (GPS) -- General concepts -- Part 2: Basic tenets, specifications, operators, uncertainties and ambiguities
ISO/IEC Guide 98-3:2008 Uncertainty of measurement -- Part 3: Guide to the expression of uncertainty in measurement (GUM:1995)
ISO/IEC Guide 99:2007 International vocabulary of metrology -- Basic and general concepts and associated terms (VIM)
ISO/TR 14253-6:2012 Geometrical product specifications (GPS) -- Inspection by measurement of workpieces and measuring equipment -- Part 6: Generalized decision rules for the acceptance and rejection of instruments and workpieces