Resistance welding. Destructive testing of welds. Specimen dimensions and procedure for mechanized peel testing resistance spot, seam and embossed projection welds (ISO 14270:2016)
Tuote ladattavissa hetiToimitusaika on noin 1 - 2 työpäivääToimitusaika on 3 - 5 työpäivää.
ISO 14270:2016 specifies specimen dimensions and a testing procedure for mechanized peel testing of single spot, seam and embossed projection welds, in overlapping sheets, in any metallic material of thickness 0,5 mm to 3 mm, where the welds have a maximum diameter of 7vt (where t is the sheet thickness in mm). For welds of diameter between 5vt and 7vt, the peel strength values obtained may be lower than expected when using the recommended test specimen dimensions because the test specimen width is designed for welds of diameter of 5vt or less. The object of mechanized peel testing is to determine the peel strength that the test specimen can sustain.
Tämän julkaisun valmistelusta Suomessa vastaa Metalliteollisuuden Standardisointiyhdistys ry, puh. 09 19 231 (vaihde).
Sisällysluettelo
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Test pieces and specimens
5 Preparation of mechanized peel test specimens
5.1 General
5.2 Bending procedure of weld test specimens after welding
5.3 Bending procedure of test specimens before welding — Alternative procedure
5.4 Dimensions and accuracy
6 Peel testing procedure and test equipment
7 Re-test
8 Test report
Annex A Measurement of seam weld size (normative)
Annex B Influence of spot weld position on test results (informative)
Annex C Examples of bending tools (informative)
Annex D Determination of the bending centre position with press brake systems (informative)
ISO 17677-1:2009 Resistance welding -- Vocabulary -- Part 1: Spot, projection and seam welding
ISO 7500-1:2015 Metallic materials -- Calibration and verification of static uniaxial testing machines -- Part 1: Tension/compression testing machines -- Calibration and verification of the force-measuring system
ISO 17677-1:2009 Resistance welding -- Vocabulary -- Part 1: Spot, projection and seam welding
ISO 7500-1:2015 Metallic materials -- Calibration and verification of static uniaxial testing machines -- Part 1: Tension/compression testing machines -- Calibration and verification of the force-measuring system