ISO 15118-3:2015 specifies the requirements of the physical and data link layer for a high-level communication, directly between battery electric vehicles (BEV) or plug-in hybrid electric vehicles (PHEV), termed as EV (electric vehicle) [ISO-1], based on a wired communication technology and the fixed electrical charging installation [Electric Vehicle Supply Equipment (EVSE)] used in addition to the basic signalling, as defined in [IEC-1]. It covers the overall information exchange between all actors involved in the electrical energy exchange. ISO 15118 (all parts) is applicable for manually connected conductive charging. Only "[IEC-1] modes 3 and 4" EVSEs, with a high-level communication module, are covered by this part of ISO 15118.
Tämän julkaisun valmistelusta Suomessa vastaa Yhteinen Toimialaliitto, www.ytl.fi.
Sisällysluettelo
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and abbreviated terms
5 Conventions
5.1 Definition of OSI based services
5.2 Requirement structure
5.3 Normative references convention
6 System architecture
6.1 Communication layers overview
6.2 Definition of high-level communication and basic signalling
6.3 Identification requirements
6.4 System requirements
6.5 Configuration of a low-layer communication module
7 Connection coordination
7.1 General
7.2 Overview
7.3 Plug-in phase
7.4 Initialization phase
7.5 Loss of communication
7.6 Sleep mode and wake-up
7.7 Plug-out phase
8 Timings and constants
9 Matching EV — EVSE process
9.1 Overview
9.2 Initialization of matching process
9.3 Discovery of the connected low-layer communication module
9.4 Validation of matching decision
9.5 Set-up a logical network
9.6 Leave the logical network
9.7 Error handling
10 EMC requirements
11 Signal coupling
12 Layer 2 interfaces
12.1 Overview
12.2 Data SAP
12.3 Data link control SAP to layer 3
Annex A HomePlug Green PHY on control pilot line (normative)
Annex B IEEE 1901.2 G3-PLC profile on control pilot line (informative)
IEC 61851-1:2010
IEC/TS 62763:2013
ISO 15118-1:2013 Road vehicles -- Vehicle to grid communication interface -- Part 1: General information and use-case definition
IEC 61851-1:2010
IEC/TS 62763:2013
ISO 15118-1:2013 Road vehicles -- Vehicle to grid communication interface -- Part 1: General information and use-case definition
ISO 15118-2:2014 Road vehicles -- Vehicle-to-Grid Communication Interface -- Part 2: Network and application protocol requirements