ISO 3040:2016 specifies graphical indication applicable to a cone (right-angle circular cones) to define its dimensioning or to specify its tolerancing. For the purposes of this International Standard, the term "cone" relates to right-angle circular cones only (any intersection by a plane perpendicular to the axis of the nominal cone is a circle). NOTE 1 For simplicity, only truncated cones have been represented in this International Standard. However, this International Standard can be applied to any type of cone within its scope. NOTE 2 This International Standard is not intended to prevent the use of other methods of dimensioning and tolerancing.
Tämän julkaisun valmistelusta Suomessa vastaa Metalliteollisuuden Standardisointiyhdistys ry, puh. 09 19 231 (vaihde).
Sisällysluettelo
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Graphical symbol for a rate of taper for a cone
5 Dimensions and indication on a cone
5.1 Dimensions on a cone
5.2 Indication of rate of taper value on drawings
6 Tolerancing of a cone
Annex A Tolerancing of a cone: Examples (informative)
Annex B Relation to the GPS matrix model (informative)
ISO 1119:2011 Geometrical product specifications (GPS) -- Series of conical tapers and taper angles
ISO 81714-1:2010 Design of graphical symbols for use in the technical documentation of products -- Part 1: Basic rules
ISO 1119:2011 Geometrical product specifications (GPS) -- Series of conical tapers and taper angles
ISO 81714-1:2010 Design of graphical symbols for use in the technical documentation of products -- Part 1: Basic rules