Gas cylinders. Seamless, welded and composite cylinders for compressed and liquefied gases (excluding acetylene). Inspection at time of filling (ISO 24431:2016)
Tuote ladattavissa hetiToimitusaika on noin 1 - 2 työpäivääToimitusaika on 3 - 5 työpäivää.
ISO 24431:2016 specifies the inspection requirements at the time of filling, and applies to seamless or welded transportable gas cylinders made of steel or aluminium-alloy (Type 1), and for composite transportable gas cylinders (Types 2 to 5 inclusive) for liquefied or compressed gases of a water capacity up to 150 l. It may be applicable to cylinders and tubes with a water capacity between 150 l and 450 l, provided they are inspected and filled as individual cylinders and tubes. ISO 24431:2016 does not apply to acetylene cylinders, bundles of cylinders, tubes, multiple-element gas container (MEGCs) or battery vehicles. ISO 24431:2016 may also be applicable to LPG. For specific LPG applications, refer to ISO 10691. For cylinders manifolded in bundles, refer to ISO 11755.
Tämän julkaisun valmistelusta Suomessa vastaa Kemesta ry, puh. 040 820 4888.
Sisällysluettelo
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Identification of cylinder owner
5 Filling inspection
5.1 General
5.2 Verification of serviceable condition of individual cylinders before filling
5.3 Verification during filling
5.4 Verification after filling
6 Cylinders rejected for filling
Annex A Residual pressure check (informative)
Annex B Example of a procedure to establish a correct tare (informative)
ISO 10460:2005 Gas cylinders -- Welded carbon-steel gas cylinders -- Periodic inspection and testing
ISO 10461:2005 Gas cylinders -- Seamless aluminium-alloy gas cylinders -- Periodic inspection and testing
ISO 11623:2015 Gas cylinders -- Composite construction -- Periodic inspection and testing
ISO 10460:2005 Gas cylinders -- Welded carbon-steel gas cylinders -- Periodic inspection and testing
ISO 10461:2005 Gas cylinders -- Seamless aluminium-alloy gas cylinders -- Periodic inspection and testing
ISO 11623:2015 Gas cylinders -- Composite construction -- Periodic inspection and testing
ISO 13769:2007 Gas cylinders -- Stamp marking
ISO 25760:2009 Gas cylinders -- Operational procedures for the safe removal of valves from gas cylinders
ISO 6406:2005 Gas cylinders -- Seamless steel gas cylinders -- Periodic inspection and testing
ISO 7225:2005 Gas cylinders -- Precautionary labels