ISO 20339:2017 identifies the functional characteristics of eddy current array probes and their interconnecting elements and provides methods for their measurement and verification. The evaluation of these characteristics permits a well-defined description and comparability of eddy current array probes. Where relevant, this document gives recommendations for acceptance criteria for the characteristics.
Tämän julkaisun valmistelusta Suomessa vastaa Metalliteollisuuden Standardisointiyhdistys ry, puh. 09 19 231 (vaihde).
Sisällysluettelo
Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Probe and interconnecting elements characteristics
4.1 General characteristics
4.2 Electrical characteristics
4.3 Functional characteristics
5 Verification
5.1 Level of verifications
5.2 Characteristics to be verified
6 Measurement of electrical and functional characteristics of an array probe
6.1 Electrical characteristics
6.2 Functional characteristics
7 Surface array probes
7.1 Reference blocks
7.2 Probe motion
7.3 Reference signal — Normalization
7.4 Edge effect (measurable in the case of simple geometry, e.g. metal sheets, disks)
7.5 Response to a slot
7.6 Response to a hole
7.7 Length of coverage
7.8 Variation in sensitivity between patterns
7.9 Minimum slot length for constant probe response
7.10 Lift-off effect
7.11 Effect of probe clearance on slot response
7.12 Effective depth of detection of a sub-surface slot
7.13 Resolution
7.14 Defective element or pattern
8 Coaxial array probes
8.1 General conditions
8.2 Reference blocks
8.3 Reference signal
8.4 Absence of defective elements
8.5 Position mark of the probe (mainly for positioning)
8.6 End effect
8.7 Length of coverage
8.8 Homogeneity of axial response
8.9 Eccentricity effect
8.10 Fill effect
8.11 Effective depth of penetration
8.12 Effective depth of detection under ligament
9 Influence of interconnecting elements
Annex A Simulation of surface probe resolution (informative)
ISO 12718:2008 Non-destructive testing -- Eddy current testing -- Vocabulary
ISO 15548-1:2013 Non-destructive testing -- Equipment for eddy current examination -- Part 1: Instrument characteristics and verification
ISO 15548-2:2013 Non-destructive testing -- Equipment for eddy current examination -- Part 2: Probe characteristics and verification
ISO 12718:2008 Non-destructive testing -- Eddy current testing -- Vocabulary
ISO 15548-1:2013 Non-destructive testing -- Equipment for eddy current examination -- Part 1: Instrument characteristics and verification
ISO 15548-2:2013 Non-destructive testing -- Equipment for eddy current examination -- Part 2: Probe characteristics and verification