Verkkokauppa
SFS-ISO 20267:2017:en
Thermal spraying — Determination of interfacial toughness of ceramic coatings by indentation
Soveltamisala
Suomenkielistä soveltamisalaa ei ole saatavissa.
This document specifies a method for measuring the interfacial toughness of thermal spray ceramic coatings at room temperature based on an indentation method. The interfacial toughness is calculated from the mean length of cracks emanating from the corners of the impression induced by a Vickers hardness tester, and it is intended for use with ceramic coatings with a single layer or multilayers. The test procedures proposed in this document are intended for use in an ambient environment. This document is recommended for thermal spray ceramic coatings such as thermal barrier coatings, wear resistant coatings and electrical insulating coatings.
Tämän julkaisun valmistelusta Suomessa vastaa Metalliteollisuuden Standardisointiyhdistys ry, puh. 09 19 231 (vaihde).
This document specifies a method for measuring the interfacial toughness of thermal spray ceramic coatings at room temperature based on an indentation method. The interfacial toughness is calculated from the mean length of cracks emanating from the corners of the impression induced by a Vickers hardness tester, and it is intended for use with ceramic coatings with a single layer or multilayers. The test procedures proposed in this document are intended for use in an ambient environment. This document is recommended for thermal spray ceramic coatings such as thermal barrier coatings, wear resistant coatings and electrical insulating coatings.
Tämän julkaisun valmistelusta Suomessa vastaa Metalliteollisuuden Standardisointiyhdistys ry, puh. 09 19 231 (vaihde).
Sisällysluettelo
Tuoteryhmä(t)
Sidokset
Velvoittavat viittaukset
ISO 6507-1 Metallic materials — Vickers hardness test — Part 1: Test method
ISO 6507-2 Metallic materials — Vickers hardness test — Part 2: Verification and calibration of testing machines
ISO 6507-2 Metallic materials — Vickers hardness test — Part 2: Verification and calibration of testing machines
Tekninen komitea
Vahvistuspäivä
09.06.2017
Julkaisupäivä
13.06.2017
Painos
1
Sivumäärä
14
Julkaisun kieli
englanti