Verkkokauppa
SFS-EN ISO 11296-2:2018:en
Plastics piping systems for renovation of underground non-pressure drainage and sewerage networks. Part 2: Lining with continuous pipes (ISO 11296-2:2018)
Soveltamisala
Suomenkielistä soveltamisalaa ei ole saatavissa.
ISO 11296-2:2018, in conjunction with ISO 11296-1, specifies requirements and test methods for pipes and fittings which are part of plastics piping systems installed as continuous pipes in the renovation of underground non-pressure drainage and sewerage networks. It is applicable to polyethylene (PE) pipes of three different types:
- PE solid wall single layered pipes (nominal outside diameter, dn), including any identification stripes;
- PE pipes with co-extruded layers on either or both the outside and inside of the pipe (total outside diameter, dn), as specified in Annex A, where all layers have the same MRS rating;
- PE coated pipes (outside diameter, dn) having a peelable, contiguous, thermoplastics additional layer on the outside of the pipe ("coated pipe"), see Annex A.
In addition, ISO 11296-2:2018 covers:
- jointing of pipe lengths by means of butt fusion;
- fabricated and injection-moulded fittings made of PE.
Tämän julkaisun valmistelusta Suomessa vastaa Muoviteollisuus ry, puh. 09 172 841 (vaihde).
ISO 11296-2:2018, in conjunction with ISO 11296-1, specifies requirements and test methods for pipes and fittings which are part of plastics piping systems installed as continuous pipes in the renovation of underground non-pressure drainage and sewerage networks. It is applicable to polyethylene (PE) pipes of three different types:
- PE solid wall single layered pipes (nominal outside diameter, dn), including any identification stripes;
- PE pipes with co-extruded layers on either or both the outside and inside of the pipe (total outside diameter, dn), as specified in Annex A, where all layers have the same MRS rating;
- PE coated pipes (outside diameter, dn) having a peelable, contiguous, thermoplastics additional layer on the outside of the pipe ("coated pipe"), see Annex A.
In addition, ISO 11296-2:2018 covers:
- jointing of pipe lengths by means of butt fusion;
- fabricated and injection-moulded fittings made of PE.
Tämän julkaisun valmistelusta Suomessa vastaa Muoviteollisuus ry, puh. 09 172 841 (vaihde).
Sisällysluettelo
Tuoteryhmä(t)
Sidokset
Velvoittavat viittaukset
EN 12666-1:2005+A1:2011 Plastics piping systems for non-pressure underground drainage and sewerage - Polyethylene (PE) - Part 1: Specifications for pipes, fittings and the system
ISO 11296-1:2018 Plastics piping systems for renovation of underground non-pressure drainage and sewerage networks -- Part 1: General
ISO 12176-1:2017 Plastics pipes and fittings -- Equipment for fusion jointing polyethylene systems -- Part 1: Butt fusion
ISO 11296-1:2018 Plastics piping systems for renovation of underground non-pressure drainage and sewerage networks -- Part 1: General
ISO 12176-1:2017 Plastics pipes and fittings -- Equipment for fusion jointing polyethylene systems -- Part 1: Butt fusion
Tekninen komitea
Vahvistuspäivä
23.02.2018
Julkaisupäivä
27.02.2018
Painos
1
Sivumäärä
16
Julkaisun kieli
englanti