ISO 8099-1:2018 specifies requirements for the design, construction and installation of systems for temporary retention of sewage for subsequent disposal. It applies to small craft with a length of hull (LH) of up to 24 m. ISO 8099-1:2018 does not address waste water treatment systems.
Tämän julkaisun valmistelusta Suomessa vastaa Metalliteollisuuden Standardisointiyhdistys ry, puh. 09 19 231 (vaihde).
Sisällysluettelo
Foreword
1 Scope
2 Normative reference
3 Terms and definitions
4 General requirements
5 Materials
6 Plumbing system
6.1 Hoses and piping
6.2 Seacock fitting
7 Vent system
7.1 Venting of gases
7.2 Venting of tanks
8 Holding tanks
8.1 General requirements
8.2 Requirements for permanently installed holding tanks
8.3 Requirements for portable holding tanks
9 Pump-out fitting
10 Identification
11 Information for owner's manual
Annex A Nominal design of pump-out fitting (normative)
Annex B Typical installations for toilet retention systems (informative)
ISO 10133:2012 Small craft -- Electrical systems -- Extra-low-voltage d.c. installations
ISO 13297:2014 Small craft -- Electrical systems -- Alternating current installations
ISO 228-1:2000 Pipe threads where pressure-tight joints are not made on the threads -- Part 1: Dimensions, tolerances and designation
ISO 10133:2012 Small craft -- Electrical systems -- Extra-low-voltage d.c. installations
ISO 13297:2014 Small craft -- Electrical systems -- Alternating current installations
ISO 228-1:2000 Pipe threads where pressure-tight joints are not made on the threads -- Part 1: Dimensions, tolerances and designation
ISO 9093-1:1994 Small craft -- Seacocks and through-hull fittings -- Part 1: Metallic
ISO 9093-2:2002 Small craft -- Seacocks and through-hull fittings -- Part 2: Non-metallic