ISO 11297-1:2018 specifies the requirements and test methods for plastics piping systems intended to be used for the renovation of underground drainage and sewerage networks under pressure, including both hydraulically and pneumatically pressurized systems. It is applicable to pipes and fittings, as manufactured, as well as to the installed lining system. It is not applicable to the existing pipeline or any non-structural sprayed coatings or annular filler. ISO 11297-1:2018 gives the general requirements co
Tämän julkaisun valmistelusta Suomessa vastaa Muoviteollisuus ry, puh. 09 172 841 (vaihde).
Sisällysluettelo
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and abbreviated terms
4.1 Symbols
4.2 Abbreviated terms
5 Pipes at the “M” stage
5.1 Materials
5.2 General characteristics
5.3 Material characteristics
5.4 Geometric characteristics
5.5 Mechanical characteristics
5.6 Physical characteristics
5.7 Jointing
5.8 Marking
6 Fittings at the “M” stage
6.1 Materials
6.2 General characteristics
6.3 Material characteristics
6.4 Geometric characteristics
6.5 Mechanical characteristics
6.6 Physical characteristics
6.7 Jointing
6.8 Marking
7 Ancillary components
8 Fitness for purpose of the installed lining system at the “I” stage
8.1 Materials
8.2 General characteristics
8.3 Material characteristics
8.4 Geometric characteristics
8.5 Mechanical characteristics
8.6 Physical characteristics
8.7 Additional characteristics
8.8 Sampling
8.9 Regional requirements for the installed lining system
9 Installation practice
9.1 Preparatory work
9.2 Storage, handling and transport of pipes and fittings
EN 681-1:1996 Elastomeric seals - Materials requirements for pipe joint seals used in water and drainage applications - Part 1: Vulcanized rubber
ISO 4633:2015 Rubber seals -- Joint rings for water supply, drainage and sewerage pipelines -- Specification for materials
EN 681-1:1996 Elastomeric seals - Materials requirements for pipe joint seals used in water and drainage applications - Part 1: Vulcanized rubber
ISO 4633:2015 Rubber seals -- Joint rings for water supply, drainage and sewerage pipelines -- Specification for materials