Preparation of steel substrates before application of paints and related products. Specifications for non-metallic blast-cleaning abrasives. Part 7: Fused aluminium oxide (ISO 11126-7:2018)
Tuote ladattavissa hetiToimitusaika on noin 1 - 2 työpäivääToimitusaika on 3 - 5 työpäivää.
This document specifies requirements for fused aluminium oxide abrasives, as supplied for blast-cleaning processes. It specifies ranges of particle sizes and values for apparent density, bulk density, Mohs hardness, moisture content, conductivity of aqueous extract and water-soluble chlorides. The requirements specified in this document apply to abrasives supplied in the "new" condition only. They do not apply to abrasives either during or after use. Test methods for non-metallic blast-cleaning abrasives are given in the various parts of ISO 11127. NOTE 1 Information on commonly referenced national and international standards is given in Bibliography. NOTE 2 Although this document has been developed specifically to meet requirements for preparation of steelwork, the properties specified will generally be appropriate for use when preparing other material surfaces, or components, using blast-cleaning techniques. These techniques are described in ISO 8504-2.
Tämän julkaisun valmistelusta Suomessa vastaa Kemesta ry, puh. 040 820 4888.
Sisällysluettelo
Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Designation of abrasives
5 Sampling
6 Requirements
6.1 General requirements
6.2 Particular requirements
7 Identification and marking
8 Information to be supplied by the manufacturer or supplier
Annex A Approximately equivalent codings for fused aluminium oxide abrasives (informative)
ISO 11127-1:2011 Preparation of steel substrates before application of paints and related products -- Test methods for non-metallic blast-cleaning abrasives -- Part 1: Sampling
ISO 11127-2:2011 Preparation of steel substrates before application of paints and related products -- Test methods for non-metallic blast-cleaning abrasives -- Part 2: Determination of particle size distribution
ISO 11127-3:2011 Preparation of steel substrates before application of paints and related products -- Test methods for non-metallic blast-cleaning abrasives -- Part 3: Determination of apparent density
ISO 11127-1:2011 Preparation of steel substrates before application of paints and related products -- Test methods for non-metallic blast-cleaning abrasives -- Part 1: Sampling
ISO 11127-2:2011 Preparation of steel substrates before application of paints and related products -- Test methods for non-metallic blast-cleaning abrasives -- Part 2: Determination of particle size distribution
ISO 11127-3:2011 Preparation of steel substrates before application of paints and related products -- Test methods for non-metallic blast-cleaning abrasives -- Part 3: Determination of apparent density
ISO 11127-4:2011 Preparation of steel substrates before application of paints and related products -- Test methods for non-metallic blast-cleaning abrasives -- Part 4: Assessment of hardness by a glass slide test
ISO 11127-5:2011 Preparation of steel substrates before application of paints and related products -- Test methods for non-metallic blast-cleaning abrasives -- Part 5: Determination of moisture
ISO 11127-6:2011 Preparation of steel substrates before application of paints and related products -- Test methods for non-metallic blast-cleaning abrasives -- Part 6: Determination of water-soluble contaminants by conductivity measurement
ISO 11127-7:2011 Preparation of steel substrates before application of paints and related products -- Test methods for non-metallic blast-cleaning abrasives -- Part 7: Determination of water-soluble chlorides