Health and safety in welding and allied processes. Equipment for capture and separation of welding fume. Part 4: Determination of the minimum air volume flow rate of capture devices (ISO 21904-4:2020)
Tuote ladattavissa hetiToimitusaika on noin 1 - 2 työpäivääToimitusaika on 3 - 5 työpäivää.
This document specifies two methods for establishing the minimum air volume flow rate. One method is dedicated for use with captor hoods, nozzles and slot nozzles with a ratio of slot length to hose diameter of 8:1 or less. The other method is dedicated for use with on-gun extraction devices. These methods are not applicable to down draught tables.
Tämän julkaisun valmistelusta Suomessa vastaa Metalliteollisuuden Standardisointiyhdistys ry, puh. 09 19 231 (vaihde).
Sisällysluettelo
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Captor hoods, nozzles and slot nozzles
4.1 Principle
4.2 Apparatus
4.3 Test method
4.4 Test report
5 On-torch extraction devices
5.1 Principle
5.2 Apparatus
5.3 Test method
5.4 Test report
Annex A Additional information for on-torch extraction (informative)
ISO 12100:2010 Safety of machinery -- General principles for design -- Risk assessment and risk reduction
ISO 21904-1:2020 Health and safety in welding and allied processes -- Equipment for capture and separation of welding fume -- Part 1: General requirements
ISO 12100:2010 Safety of machinery -- General principles for design -- Risk assessment and risk reduction
ISO 21904-1:2020 Health and safety in welding and allied processes -- Equipment for capture and separation of welding fume -- Part 1: General requirements