This document specifies a method for determining the tensile strain hardening exponent n of flat products (sheet and strip) made of metallic materials. The method is valid only for that part of the stress-strain curve in the plastic range where the curve is continuous and monotonic (see 8.4). In the case of materials with a serrated stress-strain curve in the work hardening range (materials which show the Portevin-Le Chatelier effect, e.g. AlMg-alloys), the automatic determination (linear regression of the logarithm true stress vs. the logarithm true plastic strain, see 8.7) is used to give reproducible results.
Tämän julkaisun valmistelusta Suomessa vastaa Metalliteollisuuden Standardisointiyhdistys ry, puh. 09 19 231 (vaihde).
Sisällysluettelo
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and designations
5 Principle
6 Test equipment
7 Test pieces
8 Procedure
9 Test report
Annex A International comparison of symbols used in the determination of the tensile strain hardening exponent (informative)
ISO 10113:2020 Metallic materials -- Sheet and strip -- Determination of plastic strain ratio
ISO 6892-1:2019 Metallic materials -- Tensile testing -- Part 1: Method of test at room temperature
ISO 7500-1:2018 Metallic materials -- Calibration and verification of static uniaxial testing machines -- Part 1: Tension/compression testing machines -- Calibration and verification of the force-measuring system
ISO 10113:2020 Metallic materials -- Sheet and strip -- Determination of plastic strain ratio
ISO 6892-1:2019 Metallic materials -- Tensile testing -- Part 1: Method of test at room temperature
ISO 7500-1:2018 Metallic materials -- Calibration and verification of static uniaxial testing machines -- Part 1: Tension/compression testing machines -- Calibration and verification of the force-measuring system
ISO 9513:2012 Metallic materials -- Calibration of extensometer systems used in uniaxial testing