Verkkokauppa
SFS-EN 2608
Aerospace series. Installation and removal requirements for 8° 30' adaptors, threaded, with lockring
Soveltamisala
Suomenkielistä soveltamisalaa ei ole saatavissa.
This standard specifies the installation and removal requirements for adaptors, threaded, with lockring for pipe couplings 8°30' according to EN 2603.
This standard establishes an accurate procedure of adaptor installation, removal and reinstallation to ensure the repeatability of the installation operation and to ensure the effective compliance to sealing and locking re-quirements.
The adaptor shown on all figures of this standard is given as an example for the 8°30' interface according to EN 2604.
This procedure is used for adaptors 8°30', for nominal pressure up to 28 000 kPa to install the adapters according to EN 3248, EN 3270 and EN 3566
Tämän julkaisun valmistelusta Suomessa vastaa SFS Suomen Standardit, puh. 09 149 9331.
This standard specifies the installation and removal requirements for adaptors, threaded, with lockring for pipe couplings 8°30' according to EN 2603.
This standard establishes an accurate procedure of adaptor installation, removal and reinstallation to ensure the repeatability of the installation operation and to ensure the effective compliance to sealing and locking re-quirements.
The adaptor shown on all figures of this standard is given as an example for the 8°30' interface according to EN 2604.
This procedure is used for adaptors 8°30', for nominal pressure up to 28 000 kPa to install the adapters according to EN 3248, EN 3270 and EN 3566
Tämän julkaisun valmistelusta Suomessa vastaa SFS Suomen Standardit, puh. 09 149 9331.
Sidokset
Velvoittavat viittaukset
EN 2435-001:2006 Aerospace series - Paints and varnishes - Corrosion resistant chromated two component cold curing primer - Part 001: Minimum requirements
EN 2602:2005 Aerospace series - Ports for adaptors, threaded, with lockring - Geometric configuration
EN 2603:2005 Aerospace series - Port ends for adaptors, threaded, with lockring - Geometric configuration
EN 2602:2005 Aerospace series - Ports for adaptors, threaded, with lockring - Geometric configuration
EN 2603:2005 Aerospace series - Port ends for adaptors, threaded, with lockring - Geometric configuration
Tekninen komitea
Vahvistuspäivä
06.03.2006
Julkaisupäivä
14.10.2020
Painos
0
Sivumäärä
22
Julkaisun kieli
englanti