This document specifies only the requirements for a product assembled from the in-series combination of safety valves or CSPRS (controlled safety pressure relief systems) according to ISO 4126-1, ISO 4126-4 and ISO 4126-5, and bursting disc safety devices, according to ISO 4126-2, installed upstream of the valve within five pipe diameters of the valve inlet. It specifies the design, application and marking requirements for such products, composed of the bursting disc safety device, a safety valve or CSPRS and, where applicable, a connecting pipe or spool piece. In addition, it gives a method for establishing the combination discharge factor used in sizing combinations.
Tämän julkaisun valmistelusta Suomessa vastaa Metalliteollisuuden Standardisointiyhdistys ry, puh. 09 19 231 (vaihde).
Sisällysluettelo
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols
5 Design of combination
6 Installation of combination
7 Combination performance
8 Determination of combination discharge capacity factor, Fd, by testing
8.1 General
8.2 Test requirements
8.3 Test rig
8.4 Test method
8.5 Test procedure
8.6 Acceptance criteria of the tests
9 Derivation of combination discharge capacity factor, Fd
10 Alternative to testing for Fd
11 Certification of combination discharge capacity factor, Fd
12 Application and use of the certified combination discharge capacity factor, Fd
13 Marking and identification of combination devices
ISO 4126-1:2013 Safety devices for protection against excessive pressure -- Part 1: Safety valves
ISO 4126-2:2018 Safety devices for protection against excessive pressure -- Part 2: Bursting disc safety devices
ISO 4126-4:2013 Safety devices for protection against excessive pressure -- Part 4: Pilot operated safety valves
ISO 4126-1:2013 Safety devices for protection against excessive pressure -- Part 1: Safety valves
ISO 4126-2:2018 Safety devices for protection against excessive pressure -- Part 2: Bursting disc safety devices
ISO 4126-4:2013 Safety devices for protection against excessive pressure -- Part 4: Pilot operated safety valves
ISO 4126-5:2013 Safety devices for protection against excessive pressure -- Part 5: Controlled safety pressure relief systems (CSPRS)
ISO 4126-6:2014 Safety devices for protection against excessive pressure -- Part 6: Application, selection and installation of bursting disc safety devices
ISO 4126-9:2008 Safety devices for protection against excessive pressure -- Part 9: Application and installation of safety devices excluding stand-alone bursting disc safety devices