This document specifies a method to determine the capability of a manufacturer to use friction stir spot welding (FSSW) for production of products of the specified quality. It specifies quality requirements, but does not assign those requirements to any specific product group. In this document, the term "aluminium" refers to aluminium and its alloys.
Tämän julkaisun valmistelusta Suomessa vastaa Metalliteollisuuden Standardisointiyhdistys ry, puh. 09 19 231 (vaihde).
Sisällysluettelo
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Quality requirements
4.1 General
4.2 Welding personnel
4.3 Inspection and testing personnel
4.4 Equipment
4.5 Welding procedure specification (WPS)
4.6 Friction stir spot welding tool
4.7 Pre-weld joint preparation and fit-up
4.8 Thermal control
4.9 Welding
4.10 Post-weld heat treatment
4.11 Inspection and testing
4.12 Identification and traceability
Annex A Imperfections, testing and examination (normative)
ISO 17636-1:2013 Non-destructive testing of welds -- Radiographic testing -- Part 1: X- and gamma-ray techniques with film
ISO 17636-2:2013 Non-destructive testing of welds -- Radiographic testing -- Part 2: X- and gamma-ray techniques with digital detectors
ISO 17637:2016 Non-destructive testing of welds -- Visual testing of fusion-welded joints
ISO 17636-1:2013 Non-destructive testing of welds -- Radiographic testing -- Part 1: X- and gamma-ray techniques with film
ISO 17636-2:2013 Non-destructive testing of welds -- Radiographic testing -- Part 2: X- and gamma-ray techniques with digital detectors
ISO 17637:2016 Non-destructive testing of welds -- Visual testing of fusion-welded joints
ISO 17640:2018 Non-destructive testing of welds -- Ultrasonic testing -- Techniques, testing levels, and assessment
ISO 18785-1:2018
ISO 18785-3:2018
ISO 20807:2004 Non-destructive testing -- Qualification of personnel for limited application of non-destructive testing
ISO 3452-1:2013 Non-destructive testing -- Penetrant testing -- Part 1: General principles
ISO 3452-2:2013 Non-destructive testing -- Penetrant testing -- Part 2: Testing of penetrant materials
ISO 3452-3:2013 Non-destructive testing -- Penetrant testing -- Part 3: Reference test blocks
ISO 3452-4:1998 Non-destructive testing -- Penetrant testing -- Part 4: Equipment
ISO 3452-5:2008 Non-destructive testing -- Penetrant testing -- Part 5: Penetrant testing at temperatures higher than 50 degrees C
ISO 3452-6:2008 Non-destructive testing -- Penetrant testing -- Part 6: Penetrant testing at temperatures lower than 10 degrees C
ISO 9015-1:2001 Destructive tests on welds in metallic materials -- Hardness testing -- Part 1: Hardness test on arc welded joints
ISO 9015-2:2016 Destructive tests on welds in metallic materials -- Hardness testing -- Part 2: Microhardness testing of welded joints
ISO 9712:2012 Non-destructive testing -- Qualification and certification of NDT personnel